I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hello,
I am facing an issue with SPI when the SoftDevice S132 is enabled and i cannot figure out what the problem is.
The following test works perfectly when SoftDevice...
The RADVD deamon in Raspberry pool is version 1.8.5 (up to Raspberry 2015-02-16).
root@raspberrypi:~/radvd# apt-cache policy radvd
radvd:
Installed: 1:1.8.5-1
Candidate: 1:1.8.5-1
Version table…
In SDK v8.1 we added the TWI driver (nrf_drv_twi.c). Unfortunately the nrf_drv_config.h file wasn't updated correctly with the new driver.
The symptom is the error with "TWI_COUNT is missing".
Here…
If you are looking for a place to get started with DFU, please have a look at this presentation here and the tutorial here.
In this post, we cover some in depth Q&A topics regarding Device Firmware…
This guide is for an older version of the nRF Connect SDK.
For a newer guide on Bootloaders and DFU, we recommend https://academy.nordicsemi.com/courses/nrf-connect-sdk…
Does your build fail today, even though it worked fine yesterday? Are you able to build your project on another computer, but not the one you need to use now? Here are eight things you can try to fix these…
Objectives
Learn to add and configure an I2C/TWI Master Zephyr driver to an NRF Connect SDK project.
Learn to add and configure an I2C/TWI Slave nRFX driver to an NRF Connect SDK project.
Demonstrate…
Using the nRF Connect SDK / West to Program the Radio_Test example into the nRF5340 DK
Background:
There is a need to be able to put a Nordic Semiconductors System-on-Chip / transceiver into modes where…
The "Concurrent Multiprotocol Timeslot API" was introduced with v7.0 of the S110 SoftDevice in 2014. The original purpose was to allow customers to build their own proprietary networks using…