Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
uart(with USB to UART bridge) dfu can not work 0

Hi, I use UART bootloader SDK example(dfu_dual_bank_hci) to do update firmware on EK PCA10001 board,it can work ok.But i changed the HCI_SLIP_UART_RX_PIN_NUMBER and HCI_SLIP_UART_TX_PIN_NUMBER...
- dfu with hci
971 views

0 replies

Started over 10 years ago
by jay
Not Answered
Re-connecting iOS(ANCS) takes about 20 sec. 0

Hi. I have been trying get a notification through ANCS. I have created an app which is made by modifying ble_app_ancs sample. It works basically but there is one problem...
- s110
- nrf51822
728 views

0 replies

Started over 10 years ago
by Masa
Not Answered

Consuming too much power in search mode 0

Hello, I'm using the nrf51422 with 210 softdevice. I'm trying to figure out a way for the receiving slave device to go to sleep when away from the master, but to wake...

653 views

0 replies

Started over 10 years ago
by Emily
Not Answered
bootloader for nrf51822 0

To be able to upgrade FW through UART, a bootloader for nrf51822 is required in my project. I have tried out the example bootloader in SDK. But this example is using softdevice...
- nrf51822 bootloader
1149 views

0 replies

Started over 10 years ago
by Harry
Not Answered
Possible to Flash nRF51822 from Eclipse Run icon? 0

I followed the forum posts and nan-29 to get eclipse 4.3.2 to successfully connect to JLinkGDBServer via a Segger J-Link EDU on Ubuntu Linux. I can start the GDB server...
- gdb
- eclipse
- j-link edu
- linux
849 views

0 replies

Started over 10 years ago
by Nick

Recent in Nordic blog

Optimizing Power on nRF52 Designs

notsane0

As customers reach the end of their design cycle, their attention generally falls on power optimization, especially for battery powered designs. The following are hints for achieving the lowest possible…
- 30 May 2018
New Smart Remote 3 SDK release enables cost optimized Bluetooth 5 voice remote controls

Pär H

It has been some time since we released new SDK for the nRFready Smart Remote 3 for nRF52 Series. The recently released rev 1.2 of the firmware introduces a lot of new features and improvements. This SDK…
- 24 May 2018
Accurate State of Charge Measurements For Li-Ion Batteries Using a State of Charge vs Open Circuit Voltage Lookup Table

Bjørn Kvaale

We have had a few questions on the Nordic DevZone related to state of charge estimation of Li-Ion batteries when used in conjucture with an nrf52 DK. This blog post will show you how to customize your…
- 14 May 2018
Testing Long Range (Coded PHY) with Nordic solution (It Simply Works)

Susheel Nuguru

**Project and hex files for testing this is attached in the end of this blog. Introduction There has been a lot of discussion/testing/confusion about testing the long range feature of Bluetooth Low Energy…
- 2 May 2018
Introducing experimental release of Programmer Application

Reidar Martin Svendsen

nRF Connect for desktop has proven its flexibility by being cross platform and ability to install and update applications based on users need. Motivation Our initial goal was to modernize and cover…
- 30 Apr 2018
New in nRF5 SDK v15: Strong Hardware-Based Security with Infineon OPTIGA Trust X

ChristianLesjak

Defining a business model and implementing a technical infrastructure are two major phases in building a successful product or IoT system. However, protecting the business model and your customer’s data…
- 9 Apr 2018