Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
Unable to Create New Build Config in nRF Connect (NCS 3.0) – “Add Build Configuration” Always Fails 0

Hi, I had a working project for nrf Connect NCS 3.0. I don't know what happened, but now I can't even create a new build configuration. Every time I click on "add build...
26 views

0 replies

Started 12 hours ago
by witc
Not Answered
Question Regarding Current Measurement on the nRF52840 DK (P22 Header) 0

Hello, Please forgive me for this question. I am an extreme noob. And am trying to get started with my first project. I am working with the nRF52840 DK, and I am trying...
21 views

0 replies

Started 13 hours ago
by Tubald
Not Answered
Can not receive periodic advertising reports nrf52833 0

Hi, I am trying to make the nrf52833 into an Auracast broadcast receiver (for a broadcast from my phone). I am using bindings to the softdevice controller ( https://github...
25 views

0 replies

Started 14 hours ago
by Tomer Eliahu
Not Answered
RTT viewer is not working on nRF54L15 0

Hi Nordic team, I tried to view logs from my custom nRF54L15-based MCU using J-Link RTT Viewer, but it's (printk) not working. The same prj.conf configuration was previously...
- development
- software
- nRF54L15
- zephyr
33 views

0 replies

Started 15 hours ago
by barfiii
Not Answered
Crash on nrf_pwr_mgmt_shutdown() and high current (~350 µA) in System OFF on custom PCB with E73-2G4M08S1C module 0

Hello Nordic Support Team, I am working on an nRF52-based project on a custom PCB using the E73-2G4M08S1C devboard ( https://www.cdebyte.com/products/E73-2G4M08S1C ). ...
27 views

0 replies

Started 16 hours ago
by luqman

Recent in Nordic blog

Provision, configure and control Bluetooth mesh networks with nRF Mesh

Petter Myhre

nRF Mesh are open source libraries for building your own Android and iOS Bluetooth mesh apps. It is also the name of the apps demonstrating a subset of the capabilities of the libraries. Use them in test…
- 25 Jun 2018
nRF52832 Buttonless DFU Development Tutorial - GitHub

gamnes

This tutorial is valid as of 2018-06-06, updates to tools and SDKs might have been made since then. Please review the information on http://infocenter.nordicsemi.com/ to see if any updates have been made…
- 12 Jun 2018
Optimizing Power on nRF52 Designs

notsane0

As customers reach the end of their design cycle, their attention generally falls on power optimization, especially for battery powered designs. The following are hints for achieving the lowest possible…
- 30 May 2018
New Smart Remote 3 SDK release enables cost optimized Bluetooth 5 voice remote controls

Pär H

It has been some time since we released new SDK for the nRFready Smart Remote 3 for nRF52 Series. The recently released rev 1.2 of the firmware introduces a lot of new features and improvements. This SDK…
- 24 May 2018
Accurate State of Charge Measurements For Li-Ion Batteries Using a State of Charge vs Open Circuit Voltage Lookup Table

Bjørn Kvaale

We have had a few questions on the Nordic DevZone related to state of charge estimation of Li-Ion batteries when used in conjucture with an nrf52 DK. This blog post will show you how to customize your…
- 14 May 2018
Testing Long Range (Coded PHY) with Nordic solution (It Simply Works)

Susheel Nuguru

**Project and hex files for testing this is attached in the end of this blog. Introduction There has been a lot of discussion/testing/confusion about testing the long range feature of Bluetooth Low Energy…
- 2 May 2018