Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
the latency, reachability and throughput of the DECT NR+ on the nRF9161-DK 0

How can I please analyse the latency, reachability and throughput of the DECT NR+ on the nRF9161-DK. I urgently need a solution please, it's for my bachelor thesis. Thanks...
27 views

0 replies

Started 12 hours ago
by Ismael Nde
Not Answered
A few notes regarding the nRF Connect SDK v2.8.0 and the nRF Connect & devicetree extensions and the overall experience so far... 0

Hi, I just wanted to note a few things that I found out during the usage of nRF Connect SDK v2.8.0 and its corresponding toolchain. 1. When I create a custom board with...
36 views

0 replies

Started 14 hours ago
by masterLee
Not Answered
NRF5340 QSPI XIP IS25LP128F 0

Hello everyone, I am working on a custom board based on the nRF5340 and need to implement code execution from an external QSPI memory. The board uses the IS25LP128 memory...
25 views

0 replies

Started 14 hours ago
by Andrea Boschetti
Not Answered
Extend number of devices for PAwR (Coded PHY) 0

Hi all ! I'm writing this message because I'm having problems trying to increase the number of devices in PAwR (I use Coded PHY). I based my development on the SDK 2.8...
32 views

0 replies

Started 16 hours ago
by Yannch
Not Answered
Auracast example 0

I am using NCS v2.8.0. After successfully running the headset example with one gateway, one left channel receiver and one right channel receiver am trying to get the Auracast...
27 views

0 replies

Started 17 hours ago
by JeroenT

Recent in Nordic blog

AEC-Q100 qualified nRF51824 now available for intelligent connected vehicle applications

John Leonard

nRF51824 - World's most capable automotive qualified Bluetooth SoC The nRF51824 is now available qualified to AEC-Q100 for automotive applications that demand AEC-Q100 qualified devices. The nRF51824…
- 8 Jun 2016
Building a Cross Platform Mobile App to communicate with nRF51

Mahesh Venkitachalam

Summary Construction of a cordova based cross platform mobile app that displays heart rate measurement data sent by a Nordic nRF51822 device via BLE. This data is periodically posting this to thingspeak…
- 7 Jun 2016
Measuring Lithium battery voltage with nRF52

Ole Bauck

Here is an example of a hardware setup to measure the voltage on a Lithium battery with a voltage divider on nRF52. The Lithium battery typically has a voltage range of 2.7 - 4.2 V and we (Nordic) recommend…
- 23 May 2016

Latest guides

Software and Protocols: Automating nRF91 TLS credential management via serial port AT commands

Daniel Veilleux

I have spent a bit of time recently experimenting with different TLS credential configurations using nRF91-DKs. Eventually I got to the point where I wanted to do things like swap out the certificates…
- 10 Jan 2020
Getting started: nRF Connect for Cloud Certificate Update

Joakim

The content of this guide is now covered in the documentation on nrf Connect SDK documentation page.For the most up-to-date instruction to Update Cloud Certificate please follow this link.
- 27 Sep 2019
Getting started: Thingy:91 Firmware Update using MCUboot

Joakim

The nRF Connect Programmer application now also supports MCUboot! Follow these steps to update through the programmer application or the following guide for the command line alternative. This guide shows…
- 23 Sep 2019
Bluetooth low energy: Concurrent Advertising

Håvard

I have been asked several times about variations of the following advertising scenario, so I decided to make a blog post that I can refer to, and hope it might prove useful for others out there that are…
- 9 Sep 2019
Software and Protocols: The four kinds of data you need to consider when developing an IoT product

Markus Tacker (he/him)

In this post I will give you an introduction to the four kinds of data you need to consider when developing an IoT product: Device State Device Configuration Past Data Firmware Updates It's these …
- 9 Sep 2019
Getting Started : Automate building of HEX files for your nRF Connect SDK application using CircleCI or GitHub Actions

Markus Tacker (he/him)

Continuous delivery is in important aspect of short time to market and since the nRF9160 supports firmware over the air updates we want to ship a new firmware to our development boards every time we update…
- 14 Aug 2019