Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
Declaration of en_text_rec in NRF52 NFC Record text Example 0

static void en_record_add(nfc_ndef_msg_desc_t * p_ndef_msg_desc) { /** @snippet [NFC text usage_1] */ uint32_t err_code; static const uint8_t en_payload[] = {'H'...
- 10040 132 nrf52832 s132 nfc
1127 views

0 replies

Started over 8 years ago
by Ramkumar
Not Answered
[nRf52832, LWM2M] in no-security mode can not register LWM2M server 0

Hi: environment: target board: DK52 board and run LWM2M example of IOT-SDK v0.9 router: ubuntu 16.04 on VM and runs bsserver and LWM2M server on ubuntu 16.04 ...
- lwm2m
- nrf52832
1337 views

0 replies

Started over 8 years ago
by pasta
Not Answered
Drain current on Txd pin 0

Hi, I'm interfacing a nrf51822 and a H8/3294. My question is how much can I drain a the txd pin of the H8/3294. That means my question isn't really about nrf51822. In documentation...
- output current pin
797 views

0 replies

Started over 8 years ago
by Jief
Not Answered
LFXO active with 0.5μA higher current 0

Hi, On the 3.30 of nRF52832_Rev_1_Errata_v1.5.pdf, the sleep current with LFXO active is 0.5μA higher. I am using a nRF52832 module with the low frequency crystal oscillator...
- nrf52
- s132
- lfxo
921 views

0 replies

Started over 8 years ago
by ALE
Not Answered

Wouldn't update connection params 0

Hi, I'm using nRF52832 on SDK V12.2. I add the connection params in the conn_params_init: static void conn_params_init(void){ uint32_t err_code; ble_conn_params_init_t...

985 views

0 replies

Started over 8 years ago
by John

Recent in the DevZone Blog

Provision, configure and control Bluetooth mesh networks with nRF Mesh

Petter Myhre

nRF Mesh are open source libraries for building your own Android and iOS Bluetooth mesh apps. It is also the name of the apps demonstrating a subset of the capabilities of the libraries. Use them in test…
- 25 Jun 2018
nRF52832 Buttonless DFU Development Tutorial - GitHub

gamnes

This tutorial is valid as of 2018-06-06, updates to tools and SDKs might have been made since then. Please review the information on http://infocenter.nordicsemi.com/ to see if any updates have been made…
- 12 Jun 2018
Optimizing Power on nRF52 Designs

notsane0

As customers reach the end of their design cycle, their attention generally falls on power optimization, especially for battery powered designs. The following are hints for achieving the lowest possible…
- 30 May 2018
New Smart Remote 3 SDK release enables cost optimized Bluetooth 5 voice remote controls

Pär H

It has been some time since we released new SDK for the nRFready Smart Remote 3 for nRF52 Series. The recently released rev 1.2 of the firmware introduces a lot of new features and improvements. This SDK…
- 24 May 2018
Accurate State of Charge Measurements For Li-Ion Batteries Using a State of Charge vs Open Circuit Voltage Lookup Table

Bjørn Kvaale

We have had a few questions on the Nordic DevZone related to state of charge estimation of Li-Ion batteries when used in conjucture with an nrf52 DK. This blog post will show you how to customize your…
- 14 May 2018
Testing Long Range (Coded PHY) with Nordic solution (It Simply Works)

Susheel Nuguru

**Project and hex files for testing this is attached in the end of this blog. Introduction There has been a lot of discussion/testing/confusion about testing the long range feature of Bluetooth Low Energy…
- 2 May 2018