I was doing some developement for a custom board on NCS v2.9.1 when i noticed some of the changes i was making in my prj.conf weren't being set in the application. My impression...
In my circuit I have a MOSFET which disconnects the battery. There is a GPIO pin which turns this device on and I'm using regulator-fixed to drive it during start-up. A short...
We are currently using ncs 2.9.0 on an nRF5340. We use the BT_HCI_OP_VS_READ_VERSION_INFO to determine at runtime what version of the BLE stack is present. This information...
Hi I'm trying to load a custom board with nrf9160 with the Serial LTE Modem, and route the AT commands to the UART from a coprocessor (ESP32C3) I have followed the guide on...
Hello,
we have a working system on the nrf9161 that works without zephyr. We have our own secure firmware that successfully uses the cc310 after we start the actual application...
Streamline IoT security with nRF Cloud Security Services! Enable remote provisioning of certificates and keys, simplify manufacturing, and futureproof devices.
Boost efficiency and simplify power management with Nordic's nPM1300 PMIC! Learn how to enhance battery life, enable USB-C charging, and streamline setup.
Unlock precise, energy-efficient locationing with Nordic's Wi-Fi, cellular IoT, and GNSS solutions. Learn how to optimize power and accuracy using nRF Cloud services!
Simplify IoT development with Nordic TechDocs! Access hardware, software, and cloud resources in one place, featuring powerful search and personalized tools.
Maximize battery life for IoT devices with Thread's Sleepy End Device modes! Learn how SED and SSED optimize power consumption for long-lasting solutions.