TX Power issues

[Hass]

Hello,

I am using WM02F WiFi mdule with nRF7002 SoC and i am having some issues with the TX power measurement of the WM02F WiFi module while operating it in 2.4GHz. 

I have tested these modules (ordered from Fanstel and Jetreq Components) on the same hardware and experiencing the different TX power in 2.4GHz band in all channels (1-14).

So, I was just wondering if there are any settings I have to change in the firmware, so both modules (from fanstel and Jetreq) have the same Tx power performance. the only difference on these modules i can see is 40MHz crystal but with difference order info.

Thankful for your guidance!

[Samruddhi Jadhav]

Hello,

As mentioned in my previous reply, have you had the chance to verify the output power using conducted/cabled measurements? Also, is it possible for you to share a screenshot or image of your setup as well? Can you also provide some more details about the two modules that you mentioned? Have you performed measurements with both before and is one of them made by you?

Best Regards,

Samruddhi

[Hass]

Hello Samruddhi,

No! i have done only the radiated emission measurements with 1m of distance between radio module WM02F and the e-field probe, the e-filed probe was connected to the Network analyzer. The WM02F has an integrated antenna.

I only swapped the radio module (sourced from different suppliers) on the same hardware (changed the WM02F WiFi module on same PCB) and non of theme are made by me. My test setup was as below,

[Samruddhi Jadhav]

Hello,

Our hardware expert has suggested that the next step would be to swap the chips as well so that we get to know if it is the board or the chip which is causing the lower power. 

Best Regards,

Samruddhi

[Hass]

Hello,

now i have swapped all the components on the module without any change in TX power. so my guess is it is the chip itself. and it is almost impossible for me to swap the chip on the module without damaging the chip/module! (sorry not very good in de-soldering the QFNP modules).

is there any other thing we need to look into? firmware?

Thank You!

[Samruddhi Jadhav]

Hello,

We thought that you were using two different modules, one from Fanstel and one from Jetreq. From the picture you shared, both seem to be the same so a suggestion would be to contact Fanstel about this. 

Best Regards,

Samruddhi

[Hass]

Thank you Samruddhi,

Samruddhi Jadhav said:

We thought that you were using two different modules, one from Fanstel and one from Jetreq

Yes, that is True. and the one from Jetreq has the lower TX power.

Samruddhi Jadhav said:

a suggestion would be to contact Fanstel about this. 

I have reported this issue to Fanstel, but i have'nt got any feedback from the Fanstel. That is why i thought i might get some technical insights from the Nordic Semi team.

Best Regards

Hass

[Samruddhi Jadhav]

Hello,

Let us know if you have any further questions after hearing hearing back from them and we would be happy to help.

Best Regards,

Samruddhi