Hi,
I am using ADC without external reference and no analog input in order to measure the battery level with a timer (code at the end).
I am also reading several ports...
Hi,
I'm programming the nRF51822 and save some user data into the FLASH by using pstorage_update . It works fine if I set system off mode, and wake it up. I can read back...
Hi,
I have been using nRF51822 with my Android app using Android's Bluetooth Low-Energy APIs.
In order to get more details, I am currently working on integrating the Android...
I'm looking at interfacing a typical Wheatstone bridge sensor to the nRF51822 ADC. This particular sensor only requires a mA or two for excitation and the output fits within...
When use the "nRFBeacons" app to update the info on my beacon the following happens:
Go to update tab.
Select "Connect"
Press "SW2" on beacon and see the LED begin flashing...
I am using s110 and nrf51822. I've set up up a long characteristic of 154 bytes.
Sending between 1 and 154 bytes works as expected.
Sending 155 - 160 bytes gets rejected...
Hi,
I tested the nrf beacon application, it allows only the beacons with company identifier 0x0059 (nordic's id). But i need to modify it to support all the device, how...
Hi,
I will come back to the discussion in (because it is in state "Verified Answer" I opened up a new one) :
https://devzone.nordicsemi.com/f/nordic-q-a/55197/nrf52832...
Hello All,
I am looking for a simple example which can handle GPIO interrupt on an event. Is there anything of that sort? Or the API is documented somewhere?
I am using...
i have been trying to interface the imu sensor gy-80 with nrf52840dk
but an error of on the reference main
and the thumb set instructions no memory set errors are comming...
Hi all,
I am doing some development on nRF52840 board with PCA10056.
SDK version: nRF5_SDK_15.3.0
Softdevice: s140_nrf52_6.1.1_softdevice
Testing Example: nRF5_SDK_15...
Hello
in our concurrent radio application using timeslot API there are failed assertions from time to time (10min - 10h).
Message is as above.
Stacktrace and system...
Hi,
I would like to know how much memory my application is consuming. We are using NRF SDK-15.3 version.
In View menu there is option Memory Usage, but when I build in...
Hello,
I am trying connect with the nRF52840 dongle from my android phone using nRF Connect App. The nRF52840 dongle as peripheral and I am using nRF SDK 15.20 and s140_nRF52_6...
Hi,
I have a mesh device (door sensor) with cell battery powered.
When triggered, the device power on, do mesh stack init and start mesh stack, publish a mesh message...
Hello all, is it possible to wake-up the device from deep sleep using cap sense.
How reliable is the ADC cap sense, Im little confused as some people say CapSense is not...
There is an "error" in the Mesh 4.00 friend.c:friendship_alloc(..) function, when allocating a new friend with PollTimeout greater than 2147 seconds. The LPN allows you to...
Hi,
Working with Uart + DMA on the nrf91 board, we see two issues:
1. With baudrate of 115200, we get an overrun error after getting ~6KB of data.
2. Sometimes we do...
I am trying to develop a simple uart driver based on the nrfx_uarte driver but I get compiling errors (see below).
All I have is a simple uartOpen() function for now...
Hi,
Greetings!
I am trying to develop a device called as " Gateway ", which can receive SIGmesh messages and update/send those messages to cloud server and vice-versa...
