We're looking for a Nordic nRF51822 based low profile/small USB dongle that we can use for our iBeacon software.
It would need to come complete with casing and the ability...
Hi all,
i want to establish connection between two threads in cmsis-rtos, can i use
1) semaphore to do this?
2)message queue should be used or any other ipcs can be...
Hi,
I have two CPU in our product. (STM32F2 and Nordic nrf51422).
I use serialization function to link those two CPU(refer to ble_s110_serialization sample)
But I find...
Hi,
My behavior is as follows
Turn on my device(use 51422) and advertising(2 Service and 3 Characteristic)
Turn on my cell phone(Samsung Note3),scan my device...
Hello:
I used analog IIC write MPU6050. Again after power download programs, mpu6050 can run up there ACK response. But the debug will not run. Simulation IIC because no...
Hello!
How can I communicate with my nRF24L01+ and nRF51822 at the same time. I can set up same channel, CRC-mode and I don't use ESB. But what about address? How do I set...
Hi all,
i want to know answer related to following question
1)what is use of uicr?
2)if i place some value in uicr and then change the image,then is there will be change...
Is it possible to send a CW signal at 806 MHz with the command "AT% XRFTEST = 1". The frequency 806 MHz is downlink from band 20. To optimize the antennas it would be ideal...
Hello! Is it normal, that there are 2 applications in memory after secure buttonless DFU update? Please see screenshot of memory map:
I used SDK version 16. Shouldn't...
Hi all,
My device is working as a HID device. it's working on android and iPad but not work on macOS. It's can't solve the security procedure and returning error: <info...
Hi,
I'm working on a project using a custom pcb with a 52832 chip. It has worked good for several months, but I got a Hard Fault during flashing today. Flashed it 3 times...
Hi team,
My customer is using Thingy52 for some prototype and they output some data from sensors, 2 questions:
1. What does the form of the data means as "6Q10 fixpoint...
Hi there,
Is there any certifications required for the newly developed product that is using nrf SDK and nrf52832 SOC and can we use bluetooth logo in that product?
...
Hi
I am trying to connect my nRF52832 DK with Raspberry Pi via BLE. I am able to discover the board on Pi, when bluetooth is turned on. However, I get an error on Pi saying...
Hi ...
i want to change the device name dynamically, i read my questions related to it , still not working . Here , gap_param_init i have set the flag to change the device...
To the kind attention of Nordic support team,
I have got a
1. PCA10040 board, with ble secured bootloader installed
2. PCA10056 that I usually work with every day, these...
Hi,
I'm using direct advertising in order to connect to mobile devices which were already connected to my nrf device. After the first connection, I save the mobile address...
Could it possible to reduce INIT and ADVERISE times ?
What is normal startup time for nrf52832 init peripheral for advertising?
What is the minimum possible advertising...
In the OPS register description, as well as in the files modules/hal/nordic/nrfx/mdk/nrf5340_application.h and nrf5340_network.h the HFCLKAUDIOALWAYSRUN register is incorrectly...
Hi Guys,
I'm looking for some information on how to get data from the secure side to the non-secure side of the firmware. We are building an NB-IoT GPS tracker which is...
