Hi Team,
To implement iBeacon what are the things to be take care at the peripheral side.
Whether the code for advertising the peripheral in "CoreBluetooth" and "CoreLocation...
Hi, I have both the nRF8001 dev kit and the nRF51822 Eval Kit (EK). We are using the nRF8001 for most of our project with the BLE Arduino SDK. But I wanted to just load a...
Hi,
What is the suggested method to change a pending request, and make it earlier than previously requested, without closing and reopening the session?
For example,...
Hi,
I am using a custom pcb with a nRF51422 chip, and trying to setup ANT communication between 2 modules, but the sd_ant_channel_id_set call returns an invalid address...
Hi,
To use bidirectional continuous scanning mode in ANT, I have to transmit Extended Broadcast/Acknowledged/Burst messages using ANT Msgs 0x5D, 0x5E, and 0x5F (ANT Message...
We are preparing to get BT qualification for our product, developed with the 6 stack now, however want to update to 7 when it is finally released. A comment from the testing...
What is the best way to minimize transfer in progress errors when trying to send ANT messages? I am using the S310 stack on an nRF51422. I have a busy ANT channel that is...
These posts indicate there was a problem at least at one point with the S132 SoftDevice erroneously requiring FPU:
https://devzone.nordicsemi.com/f/nordic-q-a/8133/nrf52...
On line 301 of app_timer.c there is the following code:
// No more timers in the list. Reset RTC1 in case Start timer operations are present in the queue.
if (mp_timer_id_head...
Hello,
I completely don't understand how to increase the packet size in the ble_uart example (using SDK 14.2 in both sides)!
I have two NRF52 DK boards and nothing is...
Hi all,
I'd like to design using 2ch SPI of nRF52832(as a MCU).
So, How many SPI channels of nRF52832?
And, Inform me pins of SPI port of nRF52832.
Best Regards...
Hi
I am creating bond from the Nordic device to my Android APP.
But I want to change the name of the device immediately after the bond has been created.
i.e from NEWDEVICE...
Hi all,
I am using PCA10040 with nRF5_SDK_13.0.0 and using the ble_perpheral -> ble_app_uart example.
I am trying to stream data from UART to an android phone and the...
Hi,
Just a quick question about how the ble_app_uart works.
When sending to the UART from "static void nus_data_handler(ble_nus_evt_t * p_evt)" and also receiving from...
Interrupt or main() context, or something else?
We're using S140 SoftDevice, nRF52840 and Segger Embedded Studio 3.30
We're also usinq Quantum Leaps ( https://www.state...
Hi
I am use hids, ancs and hrs services together with bonding. Phone should hold the connection with device. I am enable heart rate sensor when notification is enabled ...
Hello,
Trying to make GATT services configuration for nRF8001 chip in nRFgo studio. On services.h file generation I see Generation of source files failed window with "Generate...
Hi, Nordic team:
Now, I'm using NRF51822QFAC in a production with the SDK 10.0, the firmware includes FreeRTOS and DFU, when start the DFU in nRF-Connect APP, it can't jump...
All standard SDK examples disconnect immediately once I try to connect to from Android device. But when I flash the same sketch to nRF52-DK, I can connect successfully.
...
