Hi,
I find the CSCS example program reading zero at low cadence levels below around 50 rpm.
Using ble_peripheral example ble_app_cscs loaded into the PCA10040 board or...
I had manged to deploy and configure mesh networks on Nordic Thingy devices based on these 2 examples separately. 1. Generic OnOff models https://github.com/NordicPlayground...
Hello,
I am unable to access my SRJ profile with email id [email protected] due to two factor authentication. i do not get anything in the google authentication app...
The link for downloading nRF6939 live cd v5.4 is broken.
https://www.nordicsemi.com/Software-and-Tools/Reference-Designs/nRFready-Smart-Remote-3-for-nRF52-Series/Downlo...
Using one ADC, the current can be reduced to about 40uA after the ADC value is taken. Using a two-channel ADC, after the ADC value is taken, the current stops at about 0.4...
I'm searching for a software engineer who can help us getting OTA support between nRF52810 and PIC16 MCU.
nRF52810 must have command- and data mode over UART, Pic controler...
Hello, is it possible to use a wire antenna with nRF52832?
I have read that only PCB or chip antennas are used, so I expect the answer to be no, just wanted to confirm...
Hi Nordic Engineers!
I read the description of new SD s140 v6 and find a lot of good features.
A question 1, is this the next version that will be supported in the future...
HI，all
In normal circumstances, ios phone paired and connected to my 52832 device, when they are disconnected, ios phone can automatically reconnect the ble device. But sometimes...
Hello ,
I want to use the Button with Height level to trigger.The default is Down level to trigger.What should i do for that ? I try to set BUTTON_PULL NRF_GPIO_PIN_PULLDOWN...
Hi,
I have just added over the mesh bootloader updates for my mesh and I am curious about the MBR parameter page. I want to use that page as a swap page in my application...
I set the NRF_LOG_BACKEND_RTT_ENABLED 1 and NRF_LOG_ENABLED 1 in the bootloader and application.
After a reset, the application gets stuck in the bootloader
Or maybe (bl...
Hi,
I was importing ble_app_proximity project to Segger Embedded. I followed some tutorials and I build the project with no errors. Now, I'm trying to download it to the...
Hi everyone,
I am developing a remote control using nRF52832 chip. My prototype is currently developed in PC10040 board. The IDE is Eclipse Oxygen, and the SDK is S132...
I have a peripheral device with a custom service with 3 characteristics all of which send data to my central via notification. I've supplied each characteristic metadata with...
Hi
I have seemingly successfully created a firmware that sends a continuous carrier wave using radio_test.c from nRF5_SDK_12.1.0_0d23e2a/examples/peripheral/radio_test...
Hi there,
i am running bootloader code but facing a error that is "pstorage_platform.h" not found.i am using code from given path which is from SDK10.0.0 .what should i...
