We're looking for a Nordic nRF51822 based low profile/small USB dongle that we can use for our iBeacon software.
It would need to come complete with casing and the ability...
Hi all,
i want to establish connection between two threads in cmsis-rtos, can i use
1) semaphore to do this?
2)message queue should be used or any other ipcs can be...
Hi,
I have two CPU in our product. (STM32F2 and Nordic nrf51422).
I use serialization function to link those two CPU(refer to ble_s110_serialization sample)
But I find...
Hi,
My behavior is as follows
Turn on my device(use 51422) and advertising(2 Service and 3 Characteristic)
Turn on my cell phone(Samsung Note3),scan my device...
Hello:
I used analog IIC write MPU6050. Again after power download programs, mpu6050 can run up there ACK response. But the debug will not run. Simulation IIC because no...
Hello!
How can I communicate with my nRF24L01+ and nRF51822 at the same time. I can set up same channel, CRC-mode and I don't use ESB. But what about address? How do I set...
Hi all,
i want to know answer related to following question
1)what is use of uicr?
2)if i place some value in uicr and then change the image,then is there will be change...
I am trying to merge ble_app_uart peripheral example to ble_app_uart central to make it as to work both central and peripheral at a time.
I am using nrf52 boards and SDK15...
ble_sdk_app_blinky
Test using nRF Connect
You can also test the application with nRF Connect by performing the following steps:
Compile and program the application...
Hello Nordic support team, I broadcast data each 1 second and I use the following function (as used in many examples) to manage the power consumption. Unfortunately, I measure...
In your example you use as data type 0x09 and I dont understand why.
if I look on the Mesh Specification Mesh Beacon AD Type format
0x00 Unprovisioned Device beacon 0x01...
Hello, i have a central card nrf52840 and several peripheral cards nrf52840.
I have a program that allows me to launch the timer on the central and peripherals at the same...
Hello, I am using Linux as a central and I created python app (bluez, pygatt) which simulates the Android Blinky app. It communicates with the board and writes on the led...
Hello,
I have just started out looking into BLE and have read various articles and a book about the protocol itself. I have got a NRF52DK board and am working on a project...
Hello,
I have a problem with the NRF9E5 (cannot be selected in the list).
For several years we have been using the mentioned chip without any problems. Now we want to...
I am using BLE mesh SDK V1.0.1. I want to know the answers of following questions,
1. What are the advertising and scanning parameters used for flooding in Mesh?
2. Does...
hey, how can i get on the device pca id which is also printed on the nordic chip on the board.
i use the mesh light on off example and need this id to send beacons with...
The code was already done in another system and it worked successfully.But when I tried to build the same code in my system it shows some error like this "cannot move location...
Hello,
I have brought new PCA10056 board for BLE5 evaluation but hard part is board is not getting detected in nRFgo studio nor in Keil.
I can see COM port getting generated...
