Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hi,
We're using nRF51288 on our product and we're interested to move to nRF52.
We bought the DK (PCA10036) EV board and migrated the code.
We've noticed that the...
Hi.
I am on compiling business now. Last days i tried to do GCC compiling and quite go well. But as always on last part i find an error.
My process:
Wrote code...
hi, I want to use BLUETOOTH for Position Service,
Did nrf52840 or nrf52832 support new feature in BLUETOOTH5?
like (1)LE Extend ADV?(2)LE Periodic Advertising Create sync...
Hi
I would like to write some data to flash directly before powering off. I have a few questions:
What is the best way to know if my write operation has finished...
Hi,
The followings are more like an observation rather than a question..
We just upgraded to SDK 14, and realized that some of the RTT logs were mysteriously disappeared...
Our application is running as a peripheral on a nrf52823 with SD132.
It starts running with slower connection interval (95-100ms) which is what we initialize the stack to...
I write the code without BLE part first, all the function works good but after I add the BLE part, it cause the chip reset. it seems like a random reset. why?
Hello, we would like to release our product to the market.
Our device is a (BLE) beacon based on nrf52 which is advertising some data encoded as manufacturing specific...
Hi everyone!
I have probelem with receice data over UART. In the other MCU use core ARM as : STM32, NXP... when a byte is recieved, MCU has flag to notify. That is "interrupt...
My code is in the link attached:
github.com/.../master
With that code we have a current measurement of 1.1mA. As you can see in the code, we have tried to disable all...
Hello guys, i am Dani.
Actually i am new in hardware communication and i have problem with BLE - Android Pairing.
The details are as follows:
I was trying to perform...
Hello,
As per my requirement I want to develop a device that would be capable of sending & receiving data to & from a web server & at any point of time multiple devices...
Hi everyone,
I am using board PCA10040 v1.1.0, softdevice 13.0.0, Eclipse Oxygen. I am trying to connect my board with a device call Daydream controller .
There is also...
