Dear Nordic employee:
1、 what do I have?
I have a thingy52 develop kit（nrf52832）
2、what is my purpose?
the quality of thingy52 audio demo is not good（iphone7）...
Hello Nordic,
My development environment:
SDK>> NRF51822_SDK10, SoftDevice>> S130
Example>> ble_app_uart
I am looking forward to your reply!
Thanks.
Best Regards...
Dear friends,
according to "nRFConnect_BLE_User_Guide_v2.0", to set up a local device,i should complete the following steps:
Connect a development kit or dongle to...
Hi
I have add some function call like sd_ble_enable in mesh example, I test to get
then I set the address and all sd_ble_cfg_set is ok
but when I call "sd_ble_enable...
Nordic \ nRF5_SDK_12 nrf52832 using 2.0 _f012efa \ examples \ peripheral \ pwm_driver, pwm_driver example
Want to set up two road PWM phase is different, for example, the...
I'm using nRF52832 and S132 based on nRF5 SDK v14. I get a error code 4 when I add DFU service refer to the experimental_ble_app_buttonless_dfu . The SDK has changed so much...
Hi,
I'm wondering if I can get current transmitting channel during a connection. So
Is there a way I can directly read current transmitting channel?
If not, is...
HI,
the solution I'm working on requires quite a few IO pins, so once I ran out of regular GPIO pins I had to resort to using NFC ones.
I changed the UICR registers...
I am using the Dynastream D52DK1 ANT starter kit -based on Nordic Semiconductor’s nRF52832. According to the documentation given by Dynastream,
Open the desired project...
Hej, I stumbled upon a linker error saying
Output/serial_pca10040 nrf52832_xxaa/Obj/hardfault_handler_gcc.o: In function `HardFault_Handler_Continue':
hardfault_handler_gcc...
Hi, I really hate to ask this question but so far I have only managed to find 2 similar questions with 0 about nrf52840.
I'm using nrf52840 S140 5.0 alpha3.
When calling...
Hello
I have a problem...
'python_packages.bat' file can not be installed...
error message:
'python' is not an internal or external command, executable program,...
I have the nRF51-DK working on two separate computers with Keil v5.13 and the latest SDK. However, on my main computer I am having trouble with Keil and nRF51-DK. When I try...
Reference circuitry for nRF52832 with internal LDO setup says that C6 should not be mounted. Does it mean that DEC2 pin (32) should be simply grounded or it can be left open...
Hello everyone,
Im triying to replace the original 3D imagen from Thingy 52 Android App, but always i replace it for another one, the apps Crash when i go to Motion menu...
I have been developing a program for the nRF51-DK that reads an input value from an analogue input pin and displays this on PuTTY(terminal emulator software) using the UART...
This is for the nRF51822.
I have done some tests where I configure a pin as input with pull up enabled and then reconfigure the pin for an adc measurement with 1/3 prescaler...
