Hi, is there an available developer in my tri-state area of Minnesota, N. Dakota, or S. Dakota? Please call me if you are available for a project for hire. The developer should...
I'm trying to design a very low power sensor that takes readings using ADC and SPI 200 times a second. I'm a bit worried by the current EasyDMA uses (1.1mA). As far as I can...
Hi, I am working on a project where I want to make one nrf51288 chip as central hub and connect that to a android phone and other salve nrf51288 .
idea similar to this: ...
Hi,
I have a code programming the nRF51422 development board to write to a Sharp Memory 96x96 pixel LCD screen using SPI.
Currently the code writes two numbers and a...
I've modified the ble_app_uart example by adding GPIOTE so that the transmitter sends a character to the receiver when a GPIO pin is toggled. This part is working well.
...
Hi,
I am working on my hardware product having nRF-51422 chipset. I just came to know from forum post that
nRF-52 chips will get arduino IDE support as standalone. I want...
Hi!
I've been using PCA10028 for a long time and I had some bricking issues but I've managed to un-brick it with "nrfjprog --recover" and everything would work again. ...
Hello everyone,
I'm developing a new device using the nRF52832 but I have 2 questions before I send my PCB to manufacture, I hope you can help me out:
Is there any...
Hi,
Congratulations on releasing nRF Connect v2.0!
Unfortunately, I'm having trouble with adding apps behind corporate SSL proxy. Is there a workaround for this?
Please...
Hi,
I am trying to change the uart example using NRF 52 with SDK 12.3, so that I would hold a button pressed and it would send the time of button being pressed after release...
Hello!
I am putting (with a wave generator) a square wave on pin 17 of the microcontroller, and I want that same wave to come out on pin 18. How do I do that? Do you have...
Hello,
I need to transfer a lot of data over USB. I configured the USB as a USB_CDC_ACM on the nrf52840.
Everything works but the problem that i'm running into is that...
Hi there,
I'm currently using micro-ecc on an nRF52 compiled using Nordic's makefiles and implementing the secp256r1 curve. I'm mirroring this in Node.js using the Crypto...
Hey,
Can the nRF52 support 'Thread' / '6LoWPAN' protocols in the future?
Can the component support it (PHY wise etc) with the right 'softDevice' stack drivers?
Thanks...
I have used nrfgo studio, nrfjprog, jlink commander. Whenever i try, it is unable to find the jlinkarm.dll. i have checked the registry, reinstalled everything, but same error...
I use example ble_app_uart_pca10028_s130, I want to change the connection parameters by changing #define MIN_CONN_INTERVAL, #define MAX_CONN_INTERVAL, but when I use oscilloscope...
Hi,
I have been using the nRF51-DK to develop a program for capacitive sensing. I want to design a custom PCB with the nRF51422 chip on it. Do I need to have an oscillator...
Hello,
Using NRF52832, I need to convert to BLE 19.2 kbits / sec bit stream, received from another processor UART. I need a sample program, which I can adapt to do this....
