But now I have a new problem that is whenever I set " PWR_UP " bit in CONFIG register then it drop the 3.3 volt vcc to 1.2 volt. I don't know why its happening. Anyway, is...
This previous question about multiple advertisements seems to be related to softdevice 7. I was unable to get a similar example working in SD/SDK8
My end-goal is to add...
We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hello ,
I'm designing an embedded system with one of your RF chips (NRF24L01+) and as far as I searched for the datasheet , It seems like NRF24L01+ doesn't have a hardware...
Hi,
This post is very old.
devzone.nordicsemi.com/.../
I have a nrf51822 chip and I'm using it as BLE and it exposes some service and characteristics and it is working...
Hello,
I am designing a 2 layer board with NRF52832 IC. I am following all design considerations and reference design mentioned in IC's datasheet provided by Nordic. I have...
Hello,
I am designing a PCB with NRf52832 IC. I have a query regarding the width of the feed line. In reference design files, the width of the feed line is 30mil. I have...
Hello,
I want to receive the More data ( >20 bytes ) in nrf51822 Board from the nRF ToolBox UART module.
is this possible?
What will be changed to be done in peripheral...
Hi,
I have designed a custom PCB using NRF52832 IC.I have followed Sparkfun NRF52832 breakout board for placement of NRF52832 IC core part(including antenna) which is similar...
Hi,
I am using nRF52832 with NUS and buttonless DFU running well next to each other (SDK13). Instead of the standard way to jump to the bootloader (writing a 0x01 to the...
We have a device running SDK 11, without a crystal. It was using:
#define NRF_CLOCK_LFCLKSRC {.source = NRF_CLOCK_LF_SRC_RC, \
.rc_ctiv = 16,
.rc_temp_ctiv = 2}
...
Background:
In a previous posting I had asked if anyone knew of BLE connection parameter guidelines for Windows 10.
The general response was, yeah ios has BLE connection...
Hi all,
I have a use case where I have about 40 buttons that can be pressed anytime. I need know when these buttons are pressed on multiple receivers devices. So every...
Hi ,
I would like to know about Bluetooth 5 compatibility with smart phones having Bluetooth 4.x
The observation is-
a)the android application scanning for BLE device...
Hi,
I'm trying to setup 3 server and 1 client.
Currently, I encountered a problem that a successful provisioning to 3 servers happened only when the power of client is...
I tried importing the Keil 5 SDK 13 project from github.com/.../nRF5-ble-timesync-demo into Segger.
I followed all the directions from devzone.nordicsemi.com/.../ However...
Hi,I have trouble when I try my nRF51822 board with example program of hrs. I use nRF Master Control in my phone to connect with my board.scanning is ok.But when it try to...
Hi guys,
I'm investigating on a problem we found in our system. It seems not related to our custom pcb or firmware, you can replicate it with the following setup.
Setup...
