I have a nRF5340PDK, Now I want to know the lowest power consumption of this chip in different condition, such as adv, connect, sleep. But I am not sure how to config the...
Hi, i am using:
-nRF 52 DK
-nRF 52832
-Sensor of Maxim Integrated
-SDK 17.0.2
I have some problems in handling the I2C through the nrfx module.
This is my ReadByte...
Hi, I have a set up consing of an nrf52840, a Raspberry pi and a Linux workstation, which communicate over IPSP following the IPSP sample from Zephyr OS. The nrf52840 is a...
what can be the starting Point for Bachelor Thesis involving BLE 5.0 devices to be deploy in mesh Network. How the challanges in the Thesis can be address and set as a Goal...
Hi,
I'm looking for a wireless solution to handle 500-1000 of Clients per area. Because i',m new to Bluetooth i don't know if this is possible.
Requirements:
Network...
Hi,
I using the application download the update firmware, and using the bootloader erase and write the firmware to flash.
And I changed the bootloader code, remove all...
Dear Nordic Developer,
I am using nRF51822 with softdevice.
What is the best approach to have a nRF51822 always discoverable? Like heart monitor for example : no need...
If I receive data on the UART that comes in via its event handler, how can I then create an event to wake up from sd_app_event_wait and do further processing from the application...
400 control modules
I'm starting a project.
I need to reach a maximum of 200 meters.
I work with PIC. I'll have to control 400 MODULE Transceive.
Which model should...
Hi,
I have modified the ble_app_hrs source code with more no of custom characteristics(approximately 10), When i press Service Discovery in the master control panel, i am...
Hi ,
For our application i created 9 rtc1 timer .
all timers are working fine.
but once i stop battery timer and start it again ,it is giving receiver link loss....
Hi,
Actually In our application we have a battery, by external source we can charge it. Now when we connect battery or external power supply directly no error is coming....
hello!
ANT protocol;
have three nrf51922 , A can find B, B can find C. but A can't find C. A. how to communicate with C by B ? And C how to return a reply?
I want to know...
Hi ,
i am using ppi channel 0 for i2c1 bus (Accelerometer).
and also i am using ppi channel 0 for i2c0 bus (LED controller).
But both are working. but some times...
