At some point in the past I had nrf51+gdb+breakpoints working just fine. I even have a bunch of __BKPT() calls in my various error handlers to trap into the debugger.
At...
Hi,
I'm trying to program nRF51822 Beacon Kit using nRF51DK. I'm trying to load the example ble_app_beacon to the beacon kit. After uploading SoftDevice 7.1.0, I try to...
Hello
I'm using the nRF51 DK and I have a UART over BLE link set up between the board and a phone with the nRF UART app. I'm trying to get the board to execute a particular...
Hello there guys i been reading your 100 pg PDF for awhile now and im yet to understand or realize how is it that i add/place/create a payload or data to send/Tx via Master...
I am interested in writing a BLE central that reads data from multiple BLE Nordic sensors. The BLE central will be running on Embedded Linux which uses the BlueZ stack.
...
Hi,
I'm trying to get S110 softdevice (v8.0.0) working with RIOT. I had some issues (I couldn't initialize TIMER1 or TIMER2 until softdevice is setup & enabled) but I think...
Hello everyone,
I got a task which I try to implement using a NRF51822 iBeacon board.
The Task:
Advertise a Device and provide a mechanism to connect without traditional...
ble_sdk_app_blinky
Test using nRF Connect
You can also test the application with nRF Connect by performing the following steps:
Compile and program the application...
Hello Nordic support team, I broadcast data each 1 second and I use the following function (as used in many examples) to manage the power consumption. Unfortunately, I measure...
In your example you use as data type 0x09 and I dont understand why.
if I look on the Mesh Specification Mesh Beacon AD Type format
0x00 Unprovisioned Device beacon 0x01...
Hello, i have a central card nrf52840 and several peripheral cards nrf52840.
I have a program that allows me to launch the timer on the central and peripherals at the same...
Hello, I am using Linux as a central and I created python app (bluez, pygatt) which simulates the Android Blinky app. It communicates with the board and writes on the led...
Hello,
I have just started out looking into BLE and have read various articles and a book about the protocol itself. I have got a NRF52DK board and am working on a project...
Hello,
I have a problem with the NRF9E5 (cannot be selected in the list).
For several years we have been using the mentioned chip without any problems. Now we want to...
I am using BLE mesh SDK V1.0.1. I want to know the answers of following questions,
1. What are the advertising and scanning parameters used for flooding in Mesh?
2. Does...
hey, how can i get on the device pca id which is also printed on the nordic chip on the board.
i use the mesh light on off example and need this id to send beacons with...
The code was already done in another system and it worked successfully.But when I tried to build the same code in my system it shows some error like this "cannot move location...
Hello,
I have brought new PCA10056 board for BLE5 evaluation but hard part is board is not getting detected in nRFgo studio nor in Keil.
I can see COM port getting generated...
As we are building our Mesh stack on the Nordic nRF52840 boards we realized that the fixes applied to mbedOS 5.9.4 would fix some of our problems. Does anyone have experience...
Hi!
SDK:nRF5_SDK_15.0.0_a53641a\examples\ble_peripheral\ble_app_ancs_c\pca10056\s140\arm5_no_packs
Development board:pca10056,V0.9.1.
Because the current process of...