If it can work with iOS blue setting will be better
I need some reference to dev hid device in IOS
but I can just find my device ,connect ok but not work.
I need to create timeout below 1ms. I would pretty much like to use timer for that because I do not want to hold the cpu inside cycle. For me it is not important the exactness...
Hi,
While testing the device firmware update through the nRFtoolbox android application, i get "device has no required service" error more frequently.
I use latest version...
I'm having some trouble successfully entering ON,IDLE mode. I have pared-down my application to do the following:
Initializes the app_timer using the scheduler:
...
I want to control GPIO toggle by PPI. Timer1 is in timer mode. CC[0] is 1000, and CC[1] is 8000.
I use compare[0] to toggle gpio18 by PPI. I also want to use compare[1] to...
Hi,
I use two evk board to connected and test the uart serialization sample(ble_s110_serialization), one is ble_app_hrs and one is ble_app_connectivity. But I have one...
Hello everybody!
I have a problem with compilers for nRF51822.
My problems: I create a pwm signal ~38Khz, duty 30% at pin 30 of nRF51822. This process is work well. I...
hi i m using nrf52 with a pi and the gatttool. pi as master and nrf52 as slave. i want to change the mtu but i got no answer from the nrf52 as you see in the log! do i have...
Hello, I have project to do, but I have too less knowledge about NRF's, I've tried almost all information sources and libraries, but no results. I have to make, that one PIC...
I lost many time and check 3 examples for various versions SDK, in all cases device can t connect to smartphone. Check with appl. "nRF UART 2.0" and last "nRF Connect". Applications...
I've spent the better part of a day trying to get the UART demo to work and I'm not having a lot of success. I did get it to connect and transmit data once - I think that...
Just noticed through some experimentation that the SD 7.1 Stack rejects Non-Connectable Advertising Parameters if the interval is less than 152.5msec? Error: NRF_ERROR_INVALID_PARAM...
Description : It is not possible to flash or debug an application with IAR on the Nordic target. This issue is caused by a bad interaction between CMSIS-DAP IF present on...
Hello,
I am developing a wireless sensor network to exchange body movement acceleration data with one Master and several Slaves. In the developing phase I am using the...
Why would sd_ble_gatts_characteristic_add() suddenly return NRF_ERROR_NOT_SUPPORTED?
It is not a documented return.
It happens only when adding a device information...
Hello,
I want to implement BLE central for Health Thermometer Service using nRF51822 with S130 SD
I used the example ble_app_hrs_c as a reference, but I don't see an...
I have a strange behavior with the Timers. For my project I use a Raytac module with a nRF52 Chip on it. Softdevice is not flashed. Project is based on SDK 11.0
When I...
My setup:
NRF52DK;
Keil 5.22.0.0;
nRF5_SDK_12.2.0;
S132 3.1.0
While trying to use ble_peripheral\ble_app_template\pca10040\s132\arm5_no_packs I decided to modify...
