Hello：
Why Bluetooth Go to system-off mode, sd_power_ramon_set can not be stored. In D: \ RAM save nrf51_sdk_v5_2_0_39364 \ nrf51822 \ Board \ nrf6310 \ s110 \ ble_app_rscs...
Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I Cant clear the RTC2 after a Compare Match. First Compare is Triggered. After that no more Interrupt is generated. Code:
static const nrf_drv_rtc_t rtc = NRF_DRV_RTC_INSTANCE...
I debugged with pca10028, but J-Link can not recognize manufacturer.
If selected cortex-M0, it works but is very inconvenient.
How can I solve this problem?
Hello,
i am meeting problem to program the SoftDevice using an example project in Keil for nrf52832.
i have tested the development kit setup use Blinky Example . it is...
Hi,
We are using sdk12.3.0 sd130 v2 on nRF51822(32KRAM version). We want one central to connect to at least 3 peripherals. We are starting with ble_app_hrs example at the...
Configuration:
nRF5_SDK_13.0.0_04a0bfd
PCA10040
ARMGCC
Background:
I have created custom service based on ble_nus service. I have created 4 characteristics with notify...
I'm concerned about users writing too much or invalid NDEF data to the NFC function.
This could result in parse errors or buffer overflows leading to system crashes/malfunction...
Good Morning,
I need help for integrating a wifi card of this type or another that may suggest. With explanation of connection in the pinp Gpio of the thingy52 board, what...
Hello everyone,
I am looking to start developing something using nfc but I am unable to do so.
I am using SDK v12 and it has nfc examples as well like "record_url" or "adafruit...
Hi,
How to integrate both over-the-air and uart bootloader application for an device? We have a custom board with nrf51822 chipset, and we need to implement the firmware...
Hello,
I'm currently experimenting with the dual-bank bootloader in SDK 13.1. According to the documentation, if the new application can be activated, it is copied from...
Hello everyone,
I'm developing a new device using the nRF52832 but I have 2 questions before I send my PCB to manufacture, I hope you can help me out:
Is there any...
Hi,
Congratulations on releasing nRF Connect v2.0!
Unfortunately, I'm having trouble with adding apps behind corporate SSL proxy. Is there a workaround for this?
Please...
Hi,
I am trying to change the uart example using NRF 52 with SDK 12.3, so that I would hold a button pressed and it would send the time of button being pressed after release...
Hello!
I am putting (with a wave generator) a square wave on pin 17 of the microcontroller, and I want that same wave to come out on pin 18. How do I do that? Do you have...
