Due to production requirements, I need to obtain the device's QR code. However, I found that the QR code can only be retrieved using the code snippet below after calling Nrf...
I am trying to create a custom sensor for CT1711 temperature sensor. I have created the sensor driver code and device tree binding, but it won't start (initialize) and the...
Hi,
Is it possible to make the MQTT connected device receive the Shadow config updates and AT Commands immediately? Based from our testing, the device only receives the...
Hi Nordic Support Team,
I'm currently experimenting with Channel Sounding using a couple of nRF54L15 boards.
I am trying to obtain raw I and Q samples so that I may analyze...
Hello,
currently i am configuring the networking stack on my project.
The goal is to use Matter's built-in Thread connection, to establish a Secure CoAP connection. I...
I am running into an issue with the Fstorage Library with SDK14 that I did not have using SDK12.
When I am not connected to BLE I can erase and write flash with no issues...
Hello,
I am trying to make BME280 sensor work with nRF51 DK. I just need temperature readings. So i searched if there was some examples using this sensor and i found this...
Seems PPK is broken, it measures ~70mA no matter what I connect it to, even only measuring on a DK in shutdown.
I suspect this happend during measuring on a custom board...
Hi We are making a project where we use Bluetooth mesh, which works fine, but we have a problem with TWI (slave), the problem is when we want to read what is on the slave...
when i use dsm_address_publish_remove() to remove a group address , it will show MESH ASSERT when i restart the board.error code is NRF_ERROR_NOT_FOUND when execute dsm_address_publish_add_handle...
I read on ANT documentation that is possible to configure different channels with different network keys.
In my project i write:
>> sd_ant_network_address_set( "ANT+NetworkNumber...
Sorry I must have missed some crucial bit of documentation.
I have some code working using GPIOTE, however the inputs of the hardware, that will connected cannot be driven...
Hello,
I have interfaced MPU accelerometer on i2c and GPS on UART. Have enabled UART and using printf to display both sensor data. To begin with, both work fine individually...
Hi,
I checked erratas for nRF52840 rev1 and #164 is gone but #191 is still there. Can I have both #164 and #191 active in my code and it won't cause problems on either engineering...
Hello,
I have a question regarding the nrf uart driver. The RXTO event is never triggered even though the Interrupt itself is enabled (and the line is idle after a packet...
hi,
In Light switch Example ahead of time he have 3 Servers so we set SERVER_COUNT=3
if I want to develop Mesh Network..Where I introduce new Node, Provision the node...
when i use other hex file, it appear every time.
after i click "yes"， i can't scan the divece?
so what the proble ? how can i use "nRF Connect " with other hex file ,...
