Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
We are using Vidar's program that is the basic samples/bluetooth/central_uart sample but with 3 board files so the program can be run on the nrf9160dk/nrf9160/ns board, in...
Hello all,
I am currently using an MDBT50Q-DB-40 from Raytac with the NRF52 DK (PCA10056) with nrf connect in vs code.
Very simply, I'm setting a GPIO to go high and low...
Hello,
I am using the nPM PowerUp application with the npm1300 Evaluation kit. I am trying to configure the bucks (1 and 2) to be on/off controlled by one of the buttons...
Hi,
I'm working on an application where I want to read a couple of characteristics to get information about the connected device before continuing doing useful stuff....
I am evaluating the nRF54L15 with the nRF54L15DK. Previously, I was developing with NCS 3.1.1 and successfully implemented a high precision frequency measurement using a timer...
Hi,
I am trying to develop a matter device, using the XIAO BLE module, which features a p25q16h external flash chip, rather than the mx25r64 present in the DK. I was able...
I am trying to use some examples to add a drivers directory on my project. While doing so I run into build errors which seem to indicate a toolchain problem. The two errors...
Getting the'{', '=', or ';' error during generate and build...
Checked the attached file for hidden characters in both notepad and vscode editors.
Can someone recommend...
Hi,
I have a custom nRF5340-based LE Audio broadcast sink built on nRF Connect SDK v3.2.0 (Zephyr 4.2.x). It scans for a broadcast source, establishes PA sync, creates a...
I am attempting to install and use the NRF Connect for vscode extension pack. I have made several attempts googling solutions posted by others facing similar issues. I am...
I am developing a BLE to LORA interface using nRF52840.
The LORA transceiver needs a 32MHz clock. Is there any way that I can get the nRF52840 to generate this?
I will...
In version 0.8 of the reference datasheet for the 54L15 (QFAA QFN-48), the capacitance value for C5 is specified as 10nF. Why was it updated to 2.2nF in version 0.9? What...
Hi!
I use nRF Cloud Lib of NCS v3.1.1. I couldn't find detailed info on how nrf_cloud_send() works with QoS > 0.
If I set QoS > 0 and get a 0 error code returned from...
Hello,
We are evaluating and developing a product using the latest nRF54L series controller and would like to know if IAR compiler support is available.
While Cortex-M33...
