Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Hi, I'm new to BLE and just started feasibility testing, using RF8001, on a small device with no IO. The device will have a unique code set at factory, and printed on label...
I had the same experience as fishman and I went back to give Eclipse a try. (Post: nRF Beacon does not build on Android studio) I tried to build it in Eclipse Luna with the...
When using the BLE device, BLE_GAP_EVT_DISCONNECTED event informs us that connection between dongle and BLE device was closed/lost.
Is there a way to know when dongle connection...
Hi, I am working on project to obtain ecg data via bluetooth. But before that I was trying to see whether I could obtain ECG signals serially through nrf52833. And I tried...
Using nrf5340 with nrf70 on a custom board.
I want to use the wifi interface to send raw wifi network packets (both in associated and non-associated modes).
I have the...
Hello Team,
As we have purchased nRF9151 DK from you, we are not able to import the exact SDK required to develop using nRF9151 DK.
Kindly please let us know how we can...
Keil SDK13 BLE OTA upgrade failure causes the device to become unbootable, requiring re-flashing. How can this be resolved? We are using the bootloader_secure_ble bootloader...
Hi,
I’m planning to launch our firmware based on NCS 3.1.0 . At this stage, I don’t intend to upgrade the SDK for at least two years after the production launch . I could...
Hi,
I am using the nPM1300 PMIC and the LED drivers configured so that:
Green LED = charging status (PMIC-driven)
Red LED = error indication
Normally,...
Hi nordic team, I have tried enabling SQSPI on the system off sample, but the power consumption jumped to 6.3mA in system off mode; I tried to disable the cpulfpr core but...
I'm using the nRF Connect extension for VS Code and running into an issue with Sysbuild where calls to cmake for building the app image and the MCUboot image will use different...
We are evaluating the nRF54LM20B for an embedded audio classification application and are trying to determine whether the Axon NPU can meet our latency and energy targets...
Hello,
I encountered an issue when using BT_LE_ADV_OPT_CODED in the bt_le_adv_param options.
When I enable BT_LE_ADV_OPT_CODED , the device cannot be scanned by other...
