I'm trying to use the ADC and internal reference to measure battery voltage on the nrf51422, while S210 is enabled.
From the example nrf51-ble-app-temp-master, I found...
I have Nokia Lumia 630 and it works well with nRF51822-EK but only with SDK nrf51822_v5.1.0.36092 and SoftDevice 6.0.0. Now I decided to try DFU OTA. I programmed bootloader...
Hello,
I found that there is a multiprotocol demo in folder Board\nrf6310\s110\experimental\ble_app_multiactivity_beacon,then I found it can implement concurrent connected...
Dear Sir
We got the problem on DFU upload firmware, it always failed in second DFU . We must unpair the device at iOS setting panel. Before next DFU.
Here is the log data...
Hi All,
My requirement is to read the data from nRF51822 device that is connected to a bluetooth and bluetooth is connected to a system using a .Net application.
I have...
Hi ,
I am trying to advertise HID Keyboard Example forever untill the device is powered off
Please let me know how to do this and also how to power optimise.
Kind...
Can I calculated elapsed time from one event using TIMER1?
If yes,how?I can not find none register which one to read for get counter value(how many ticks have passed since...
Hello, I follow
this page to start the rpi2 for 6lowpan.
when I tried to run RADVD Daemon as follow:
Set IPv6 forwarding (must be present).
sudo echo 1 > /proc...
Hello!
I recently purchased a RedBearLab nRF51822 board where I want to use several DS1820 temperature sensors.
For dealing with the OneWire (1-wire) protocol I found...
Hello,
I'm not sure if this was already asked before. I didn’t found a similar question, so here it is: When I have a function that manipulates a data structure to communicate...
In this ADC example from Nordic on GitHub, it does not appear an AIN has been selected (e.g.: no call to nrf_adc_input_select() ). I don't understand. I have been assuming...
Hi,
I am creating a central application on a Nordic nRF51 device. Our project is related to connecting to peripheral of any profile. Using the MCP I connect, bond and enable...
Hello,
For our application I have to set up two simultaneous connections between a S120 master device and two peripherals that use the S110 softdevice.
A very short connect...
Trying to send 3 20-byte packets of data from nRF51822 (peripheral device) to a Samsung Galaxy S5 (central device) and send 1 20-byte packet back, all in less than 10ms. I...
Hello,
I'm looking to bootloader sources and i want to add a timeout if entering with a signal in DFU mode and no DFU detected for one hour.
There is a timers_init function...
I have a project that requires full-duplex voice comms (doesn't need to be high-quality). I'm evaluating the suitability of BTLE for the task. The new nRF52 has a PDM module...
