I am getting following error:
Error in final launch sequence
Error executing step execute method: stepInitializeJTAGFinalLaunchSequence
java.lang.reflect.InvocationTargetException...
Dear Nordic people,
I am playing (6.0.0) with sd_flash_page_erase() and sd_flash_write() , seems to be working ok, Allways happens what I do expect, but I am not able to...
Hi,
Will PAN item #56 TWI: TWI module lock-up be fixed in the Rev 3 version of the nRF51822/51422?
Also would you happen to have a time frame as to when the Rev 3 will...
Close Bluetooth in Iphone's settings when IOS/51822 is paired and connected normally.
several seconds later, Open Bluetooth in the settings again, and observe the settings...
Hi,
I am trying to power off and/or disable a RR[0] with no success.
I am Powering OFF the watchdog in main and then successfully POWERing ON in wdt_init but then I...
Is it possible when using the S110 softdevice to limit the maximum number of packets per connection event? I would like to reduce the maximum amount of time the CPU spends...
I am using nRF51422 Evaluation Kit with the latest silicon revision which comes with programmable softdevice. The kit also contains an ANT USB-m dongle. I have followed the...
HI,
the solution I'm working on requires quite a few IO pins, so once I ran out of regular GPIO pins I had to resort to using NFC ones.
I changed the UICR registers...
I am using the Dynastream D52DK1 ANT starter kit -based on Nordic Semiconductor’s nRF52832. According to the documentation given by Dynastream,
Open the desired project...
Hej, I stumbled upon a linker error saying
Output/serial_pca10040 nrf52832_xxaa/Obj/hardfault_handler_gcc.o: In function `HardFault_Handler_Continue':
hardfault_handler_gcc...
Hi, I really hate to ask this question but so far I have only managed to find 2 similar questions with 0 about nrf52840.
I'm using nrf52840 S140 5.0 alpha3.
When calling...
Hello
I have a problem...
'python_packages.bat' file can not be installed...
error message:
'python' is not an internal or external command, executable program,...
I have the nRF51-DK working on two separate computers with Keil v5.13 and the latest SDK. However, on my main computer I am having trouble with Keil and nRF51-DK. When I try...
Reference circuitry for nRF52832 with internal LDO setup says that C6 should not be mounted. Does it mean that DEC2 pin (32) should be simply grounded or it can be left open...
Hello everyone,
Im triying to replace the original 3D imagen from Thingy 52 Android App, but always i replace it for another one, the apps Crash when i go to Motion menu...
I have been developing a program for the nRF51-DK that reads an input value from an analogue input pin and displays this on PuTTY(terminal emulator software) using the UART...
This is for the nRF51822.
I have done some tests where I configure a pin as input with pull up enabled and then reconfigure the pin for an adc measurement with 1/3 prescaler...
Hi,
Just wanted to point out that I noticed that after pressing Button 1 to put the device into connectable advertising mode, LED 3 turns on as expected. But if the connectable...
