But now I have a new problem that is whenever I set " PWR_UP " bit in CONFIG register then it drop the 3.3 volt vcc to 1.2 volt. I don't know why its happening. Anyway, is...
This previous question about multiple advertisements seems to be related to softdevice 7. I was unable to get a similar example working in SD/SDK8
My end-goal is to add...
We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hello ,
I'm designing an embedded system with one of your RF chips (NRF24L01+) and as far as I searched for the datasheet , It seems like NRF24L01+ doesn't have a hardware...
Hi,
This post is very old.
devzone.nordicsemi.com/.../
I have a nrf51822 chip and I'm using it as BLE and it exposes some service and characteristics and it is working...
Hi, I need to read a pulse signal with the nRF52840 . I tried to use the timers but it seems to go in conflict with the I2C that I use to communicate with another device....
Hi,
I am trying to make a simple function for writing via SPI. I am using the SPI example and it works fine. Now I would just like to make two SPI functions that I can use...
Hello Nordic,
I am trying to make NRF52840-DK Communication with MAX30003 ECG Board via SPI. I am using the SPI example and it works fine. Now I have made three SPI functions...
Hi,
I'm currently starting on my graduation internship. For my assignment, I have to implement a Bluetooth Mesh network using Thingy 52's. I'm currently researching what...
Hi,
in provisioner.c,
/* configure the publication parametrs for the on/off server */
case PROV__STATE_CONFIG_PUBLICATION_ONOFF:
I've changed publish_address.type...
Hi,
I am using nRF52832 and nRF5_SDK_15.0.0_a53641a.
I am writing a program with keil.
We are planning to send data from the sensor via SPI communication via nRF52832...
Working with SDK 15.0.0
I am porting code from a much older version of the SDK and as such am having to make significant changes to the way the code functions. The previous...
hello,
I am interfacing NRF52840-DK with MAX30003 ECG Board Using SPI Communication. I am using SDK15.1.0 -Peripheral-SPI example code.
I have working MAX30003 Aurdino...
I'm developing on a Laird BL652 module mounted to a custom PCB. Issue is that AIN0 and AIN1 return reduced values from what AIN2-AIN5 are showing. For this example, all pins...
hi
my question is really basic, but i am not able to find an answer anywhere else. I am trying to program the nordic using its SWDIO and SWCLK pins and am stuck as i get...
I see there is a serial bootloader dfu example, however I am unable to find an OTA Mesh DFU example.
How can I exercise the Mesh DFU OTA (not via serial connection) in side...
Dear Nordic,
i just implement uart example in one of ble example(central and peripheral example) ported from ble uart app example
i face some problems
i configured pins...
