I have a working project where pin 16 is configured as a low-level interrupt source.
it is working well with SDK 15.3
after porting to SDK 17.0.2, it is not triggering...
Hello Nordic Support Engineers and fellow developers ...
Just a note to thank everyone for help via this forum. I started very inexperienced with Nordic SDK a year ago and...
Hi,
I recently purchased a thingy91 for a project. I'm trying to follow instructions from a Nordic youtube video ( https://www.youtube.com/watch?reload=9&v=xQ7hDzRULJQ ...
I have a nRF5340PDK, Now I want to know the lowest power consumption of this chip in different condition, such as adv, connect, sleep. But I am not sure how to config the...
Hi, i am using:
-nRF 52 DK
-nRF 52832
-Sensor of Maxim Integrated
-SDK 17.0.2
I have some problems in handling the I2C through the nrfx module.
This is my ReadByte...
Hi, I have a set up consing of an nrf52840, a Raspberry pi and a Linux workstation, which communicate over IPSP following the IPSP sample from Zephyr OS. The nrf52840 is a...
I am new to PCB and embedded devices in general, but I have decided to try to learn :)
I have started looking at parts for my PCB design and wanted to use nRF51822-QFAA...
Dear Nordic developers,
I'm developing multiprotocol application by combining BLE and a proprietary protocol by using timeslots. In my project I need to disable BLE for...
Hi Nordics!
I am trying to merge my hex files.
I followed this post.
devzone.nordicsemi.com/.../
First, I made a .bat file in the \bin folder.
merge_test.bat...
Hi,
i have a bunch of nrf51822 hwid 0024 or 001E.
With softdevice s110 version 7 everything worked fine, but starting with 8, they pretend to work fine (no error codes...
Using the pure-gcc makefiles, at present I only see this for a stack trace in the command line gdb client:
(gdb) bt
#0 0xfffffffe in ?? ()
#1 <signal handler called>...
If you have the most trivial main.c possible, with a main() which does nothing at all, compile, link and load it at 0x00000000, it runs fine and does nothing .. that's basically...
I have a nRF51822 program in which a button triggered event doesn't work as expected and crashes the program. The program may have potential race condition problem. Here is...
Hello,
I've overcome most of my problems using this wonderful Q&A system from other people. Recently I've moved from a nRF8001 + MCU to a nRF51
Using SDK 8.1.1, keil...
Hi all-
I apologize in advance for the noob question but I have spent loads of time on this and can't make progress. I am trying to work my way through the nrf51822 User...
I want to experiment with recording observations of the beacons with raspberry pi's.
Is there any precompiled firmware I can install on the nRF51822 smart beacon...
Is it possible to add a payload (1-2 bytes) to the beacon advertising packet?
I intend place an ADC output to the payload. For now, I'm using nRF51-DK but later wants to...
Hello,
I'm developping an application using softdevice S130 with the nRF51822 evaluation kit.
The device has to scan multiple devices, and to save power, I'm storing the...
The SDK defines functions for operating on "ports", which are the output space divided into 8-bit chunks:
nrf_gpio_port_clear
nrf_gpio_port_dir_set
nrf_gpio_port_read...
