After ping through link local address ,i am not getting any Router solicitation messages,neighbor solicitation messages and neighbor advertisement messages while i am capturing...
Hi I've got my nRF8001 breakout board ready I now need the SDK in order to start developing firmware code.
I don't have any registration key, how do I get hold of it? ...
Hi,
I'm running Mac OS X 10.10.2 with the nRF51-DK PCA10028 card that I received today. I started off following the instructions in this article , and was able to get JLinkExe...
Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
I am trying to implement UART service which should act as both central and peripheral at a time.
So, I started implementing ble_uart peripheral service into the central...
Hi,
I'm testing the nrfutil tool for DFU in windows but it seems that when running nrfutil keys --gen-key private_key.txt I get " no such option: --gen-key" , using nrfutil...
Hello,
I have been developing firmware on a custom nRF51 board.
Upon testing firmware that involved BLE advertising,scanning, UART communication over BLE and FDS, i observed...
hi i have made gate opener for my farm, i am using MPU9250 and nrf52 to measure how much degree its open i am putting my MPU in cycle mode to wake up and take data, but it...
Hello
I would like to point out that I have no knowledge of electronics.
I am in the advanced stages of building a project on the basis of Adafruit feather nRF52832, The...
I am trying to test the fatfs example (SDK14) using the 10056 DK.
I do nothing modification and it results in...
<info> app: FATFS example started. <info> app: Initializing...
I realize I am like the hundredth person to have this problem but all the solutions I have found don't seem to work.
I am trying to add a simple header file to the nordic...
I am new to Nordic, I am able to compile and run examples on nRF52-DK.
I know there are examples are done for us but how I can develop my own project which use multiple...
I just replaced SDK 14.0 with the shiny new SDK 14.1 in my project. My project uses components from the SDK, but I don't use the exact same structure. Once again, it won't...
My Environment
Nrf52840
SDK : nrf51_15.0.0
soft device : s140
Target : Scanner (central)
I am trying to set GAP parameter for listening single channel that is...
i use sdk14.2 52832 i use uart
UART0_CONFIG_USE_EASY_DMA =1 consumption ~2.1mA
UART0_CONFIG_USE_EASY_DMA =0 consumption ~650uA
Is this a normal phenomenon, is it true...
Hi,
I have a Development and Evaluation board by Waveshare and i have a nRF51822 board. I have downloaded the nRFgo studio and i have used a USB to UART board and connected...