HI,
I want to use PWM to control various hardware (LED's, etc ..) so I started off from the suggested PWM code example, found in this forum + modified it as I want to use...
hello,
the function ble_stack_init () in the example of ble_app_uart are quite different from that in the example of ble_app_proximity in my first sight.
ble_app_uart :...
I am getting following error:
Error in final launch sequence
Error executing step execute method: stepInitializeJTAGFinalLaunchSequence
java.lang.reflect.InvocationTargetException...
Dear Nordic people,
I am playing (6.0.0) with sd_flash_page_erase() and sd_flash_write() , seems to be working ok, Allways happens what I do expect, but I am not able to...
Hi,
Will PAN item #56 TWI: TWI module lock-up be fixed in the Rev 3 version of the nRF51822/51422?
Also would you happen to have a time frame as to when the Rev 3 will...
Close Bluetooth in Iphone's settings when IOS/51822 is paired and connected normally.
several seconds later, Open Bluetooth in the settings again, and observe the settings...
Hi,
I am developing firmware based on nRF51822 SDK for s110.
I would like to modify one or two bytes at Manufacturer Specific Data area in advertising data packet.
But...
Using nrf51822's PCA10001EK and trying the included s110 example called ibeacon. Keep hitting error 0x3001 which corresponds to "connection handle" error.
This error is...
I have not been able to make this app work. I programmed S120 as softdevice and loaded the application. Ran into problem with scatter file. I changed it based on the s120...
When sending data on a pipe with ACK (indicate), the acknowledgement seems to get lost if the device gets disconnected right after having sent that data. Is that a normal...
Hello,
I am trying to build a single device, lets say loaded with firmware "A".
I would like to have two of these devices, both with firmware "A" to detect proximity...
I can't find anything to indicate for sure that the S120 BLE softdevice will work on the nRF51422 BLE/ANT chip. I'm pitting BLE vs ANT for my current use case and being able...
nRf51422 flash data retention is 10 years at 40°C. We need for our application (motor control roller shutter) 20 years. What can you do to increase this value?
Hi All,
Please correct the following in my understanding. Also , i am planning to build a
remote controlled device using a PWM output. How does ATT,GATT and GAP affect/influence...
I recently purchased an nRF51822-mKIT and I'm having great difficulties in getting it to talk to either a Windows 7 or a Windows 8 desktop PC, or a Ubuntu linux desktop PC...
Hi.
I have just a question:
Can the same device work with gazell protocol and bluetooth LE alternatively?
I want a net with a host and some devices, but host must be...
I've somehow lost the ability to perform over the air DFU from Master Control Panel.
I have reinstalled the J-Link drivers, nrfgo studio, I've flashed the PCA10000. I can...
My board works most of the time are very good，but one time i power down the board when ble connecting and data transmitting，the board can't work when power on.and i can't...
Hello,
I am trying to use ble_app_uart example from pca10001 to nrf6310 board from development kit. My nexus 7 detects the BLE device as 'Nordic_UART' but disconnects immediately...
