I am trying to setup SPI00 as SPI slave on nrf54l15 but not work as expected.
My board configure is like
and c program like
The program intends to use nrf54L15...
Hi everyone,
These days I'm evaluating the Nordic nRF5340 to manage audio from two microphones to one dongle station. To achieve this, I configured two nRF5340s as unicast...
Hello,
I am currently evaluating MCELL location on an existing project, based on nRF9160.
After some trial and errors, I managed to get it working.
However, I ma a bit...
HI
I am currently using the nRF54L15 chip with NCS 3.2.1, carrying out secondary development based on the periodic_sync_conn sample project. I intend to adjust the transmit...
Hi,
We are developing an application that requires synchronization between two or more nRF9160-based devices. We have the following requirements and constraints:
Required...
I'm using the prebuilt Aliro stack (libaliro.a, nRF52840), when a session fails inside the library we have no way to get the resulting AliroErrorCode. The stack entry points...
Hello
We are using nRF5340 as our EVK with a 12 antenna array plate(4x4 with center 4 ones not being there). Our beacon uses nRF52833.
We used Nordic's sample codes- ...
I am trying to use fstorage with softdevice, I have replicated the flash_storage_example in my project. I have enabled all thing in sdk_config.h like shown in the example...
Hey experts, We encountered a problem about project porting and using KEIL compiling. Here are detailed: Our products are using gcc+makefile method to compile and generate...
Hi all
have used the LIS2DH successfully with the nRF52810, now have upgraded to the nRF52832. The SPI lines are not working at all i.e. when I scope them they are all...
Hi all
Will like to know what is the most suitable programming language to program Nordic Microcontrollers and do Nordic provide any software training for developers regarding...
Platform: NRF52832 custom board. SDK11 S132 V2.0
Produced 2600 pcb's. Most function as expected. However, 40 or so boards run normally only when using the debugger. The...
Vdd generated from Vddh is unstable without connected debugger and with non-started soft device
We are developing a battery powered device based on nRF52840 on custom PCB...
I'm using nrf52 S140.
We have a working product that exposes various custom services and charateristics. However, in nrfConnect these are extremely hard to understand because...
On SDK16.0.0 + Mesh SDK 4.1.0
I am getting random softdevice asserts when running our application with TWI accessing a temperature/humidity sensor (HTU21D/HPP845). Sometimes...
Hello,
I merged the two projects usbd_cdc_acm_pca10056 (A) and ble_app_hids_mouse_pca10056_s140 (B).
Currently, I'm trying to make it running again by line by line add...
Hi there!
Let's start by explaining why this is necessary. Every device will contain an RFID tag and the RFID tag number has to be equal to the address of the device it...
I have made a custom board using NRF52832 (NRF52832-QFAA-R/QFN-4) with 32MHz and 32.768 kHz crystal. The SDK is nRF5_SDK_17.0.2_d674dde. It can be connected using nRF52840...
During the initialisation adding gatt attributes with the function "sd_ble_gatts_characteristic_add" i get the error NRF_ERROR_NO_MEM. So it seems the default table size is...
