After ping through link local address ,i am not getting any Router solicitation messages,neighbor solicitation messages and neighbor advertisement messages while i am capturing...
Hi I've got my nRF8001 breakout board ready I now need the SDK in order to start developing firmware code.
I don't have any registration key, how do I get hold of it? ...
Hi,
I'm running Mac OS X 10.10.2 with the nRF51-DK PCA10028 card that I received today. I started off following the instructions in this article , and was able to get JLinkExe...
Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
Hi,
Greetings !
I want to take continuous 40 reading of adc by varying time interval between readings based on RPM value. I want timer interval resolution from 6 Sec...
Hi,
We are using nRF52840 on our product. Since we want to support USB function, we connected VBUS pin of the chipset directly to the USB connector.
We would like to know...
Hello there,
How can I activate long range (coded PHY) in IoT examples, especially in TCP Client application. I've searched that forum and all of entries discussing about...
After receiving my Thingy:91, all was working as expected until I found that the included 10MB of data on the iBasis SIM had been used up and the device refused to connect...
Using the nrf52840 for analog sensor measurements we wanted to increase the accuracy by doing a regular calibration. Doing so we sometimes noticed spurious changes in measurement...
Hi,
I am currently working on a project that requires the control of a BLDC and i am new to the nRF microcontroller is there anyone how can give me some sort of guide and...
Hi all,
i'm testing a feature of my project using the ble_app_blinky central example adapted for the nRF52840 dongle. My goal is to discover the devices that are advertising...
Hello All,
I am working on the development of a product based on the nFR52840 SoC (SDK 16 and softdevice 14) and have several pheripherals connected to the chip, one of...
Hello,
I have a problem with reporting attribute: I am currently implementing a custom cluster that has 5 attributes that are reportable. Attribute values are of the type...
Hi,
i'm working on NRF9160 DK, and I am using the aws fota test example, however when I try to compile I get the following error message: zephyr / linker.cmd: 70 cannot...
Greetings,
I ran separately both the serial and provisioner examples successfuly with NRF52832 DK. Presently I'm trying to implement serial example codes to provisioner...
Hi, I have developed the custom services for nrf52832 with sdk16 in SES
in write character
Sometimes the write option works fine
unexpected error after write function...
