Hello,
I'd like to ask what is the data rate when using BLE OpenMesh network and how much it depends on network architecture.
I'm considering using it in a network consisting...
Hello Nordic Community,
I need to know how to import my PCB design from Eagle to CST Studio to simulate it and I need to know if the simulation step will be useful to enhance...
Hi.
I'm trying to get Apple notifications to nrf52. And specifically to listen both regular ANS (for android) and ANCS (for iOS) events depending what sort of phone is...
I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hello,
I need to transfer a lot of data over USB. I configured the USB as a USB_CDC_ACM on the nrf52840.
Everything works but the problem that i'm running into is that...
Hi there,
I'm currently using micro-ecc on an nRF52 compiled using Nordic's makefiles and implementing the secp256r1 curve. I'm mirroring this in Node.js using the Crypto...
Hey,
Can the nRF52 support 'Thread' / '6LoWPAN' protocols in the future?
Can the component support it (PHY wise etc) with the right 'softDevice' stack drivers?
Thanks...
I have used nrfgo studio, nrfjprog, jlink commander. Whenever i try, it is unable to find the jlinkarm.dll. i have checked the registry, reinstalled everything, but same error...
I use example ble_app_uart_pca10028_s130, I want to change the connection parameters by changing #define MIN_CONN_INTERVAL, #define MAX_CONN_INTERVAL, but when I use oscilloscope...
Hi,
I have been using the nRF51-DK to develop a program for capacitive sensing. I want to design a custom PCB with the nRF51422 chip on it. Do I need to have an oscillator...
Hello,
Using NRF52832, I need to convert to BLE 19.2 kbits / sec bit stream, received from another processor UART. I need a sample program, which I can adapt to do this....
Hi I was use example ble_app_uart with SDK 12.3.0 and nrf51802 for a data transport, after BLE connection, the example need uart receive more than 20 or "\r\n" ,the data will...
Hi, for carrier and modulation carrier signal is confusing.
What is the difference between their center frequency point for same frequency? Or modulated carrier will...
