Hi,
Has anyone converted the Adafruit graphics library for Arduino, Adafruit_GFX.h, to be compatible with the nRF51?
Could you please advise on how to convert this Arduino...
Hi all,
I have a few questions:
How is that ADC's common mode rejection capabilities? Rejection for 60 Hz interference, etc...
The datasheet has "typical...
Hi all !
I'm trying to evaluate the throughput i can have between a Motorola 4G and the nrf51. The nRF51 is the peripheral and the phone is acting as a central.
To do...
I have a digital microphone chip, it has the CLK, DATA, LR_SEL three pins, now I will pick up the three pin nrf5283 three pin is as follows: CLK connectionI2S_CONFIG_SCK_PIN...
Hello, Nordic Team, I'm embedded designer from Russia, discovered your amazing wireless MCU NRF52832. I looked through your SDK and peripheral drivers, and unfortunately found...
Thanks Stefan. The zip file making and updating steps work perfectly for me, if I follow your steps and make it from your stock pre-built "dfu_test_app_hrm_s132.hex". My question...
Hi,
I'm looking for a wireless solution to handle 500-1000 of Clients per area. Because i',m new to Bluetooth i don't know if this is possible.
Requirements:
Network...
Hi,
I using the application download the update firmware, and using the bootloader erase and write the firmware to flash.
And I changed the bootloader code, remove all...
Dear Nordic Developer,
I am using nRF51822 with softdevice.
What is the best approach to have a nRF51822 always discoverable? Like heart monitor for example : no need...
If I receive data on the UART that comes in via its event handler, how can I then create an event to wake up from sd_app_event_wait and do further processing from the application...
400 control modules
I'm starting a project.
I need to reach a maximum of 200 meters.
I work with PIC. I'll have to control 400 MODULE Transceive.
Which model should...
Hi,
I have modified the ble_app_hrs source code with more no of custom characteristics(approximately 10), When i press Service Discovery in the master control panel, i am...
Hi ,
For our application i created 9 rtc1 timer .
all timers are working fine.
but once i stop battery timer and start it again ,it is giving receiver link loss....
Hi,
Actually In our application we have a battery, by external source we can charge it. Now when we connect battery or external power supply directly no error is coming....
hello!
ANT protocol;
have three nrf51922 , A can find B, B can find C. but A can't find C. A. how to communicate with C by B ? And C how to return a reply?
I want to know...
Hi ,
i am using ppi channel 0 for i2c1 bus (Accelerometer).
and also i am using ppi channel 0 for i2c0 bus (LED controller).
But both are working. but some times...
