Hi,
I am using the NRF8001 in UART mode and attempting to bond with my android device (Lollipop 5.0 Nexus 6).
i am using the nordic arduino sdk which is found here:...
Hi, I'm using the nRF8001 in an application that requires security so bonds to the remote client/central. My device supports firmware upgrades that may involve new nRF8001...
Hello.
Initially when reading the Gazell documentation I didn't think it'd be a problem but now in Keil seeing this has introduced some doubt whether it's a thing:
...
We would like to be able to calibrate the rRF9E5 ADC
Our proposal is to permanently fit voltage dividers, each using two precision resistors, on two of the ADC Ports and...
At some point in the past I had nrf51+gdb+breakpoints working just fine. I even have a bunch of __BKPT() calls in my various error handlers to trap into the debugger.
At...
Hi,
I'm trying to program nRF51822 Beacon Kit using nRF51DK. I'm trying to load the example ble_app_beacon to the beacon kit. After uploading SoftDevice 7.1.0, I try to...
i have integrated the uart relevant parts from the app_ble_uart example to the pwm_driver example, i did the modifications to the sdk_config and defines
i get an error while...
I've been looking through the twi_master_using_app_twi example and been trying to change things around for use with a TMP116 instead of a LM75b. I noticed from the LM75b's...
I have been searching for the best way to authenticate / authorize a mobile phone with a nRF52 device without much luck.
I would like to ensure that only the owner of the...
In my situation, I want to use bluetooth to designed a piconet which has 1 master and up to 4 slave .
With yours suggestion,Now i make it work,in upload from slave to master...
I want to include a timer within a structure and also within an array. However the SDK uses a macro to define the declaration of a timer. App_timer.h recommends not to define...
Hi,
I am using nRF52840 and nRF52832.
1) I am seeing below statement in Product specification of nRF52840 under section “7.1 Pin assignments”. What does this mean...
Hi Nordic. I am using nrf mesh sdk v4.10 and an nrf52840.
I would like to report a potential bug regarding the Light LC server.
According to the mesh specification regarding...
Hello,
I have a strange Problem. I have a Central Application where the Central will get a TagID via Uart and if there is a adv. from this Tag the Central will connect to...
Hi Team,
We are using MBN52832 Murata module in our ongoing project.We need technical support from the team.
We need hardware integration (connection) support from the...
Every once in a while I am experiencing the soft device error NRF_FAULT_ID_SD_ASSERT.
In this post I saw that you may be able to provide some information on what is going...
Hello everyone,
I work with a custom board with the nRF52840 chip on it. We have pressure, humidity and temperature sensor and accelerometer sensor on the board. We need...
Hi,
We have a product that have a BLE capability (not by Nordic) and already have a mobile app that works with it.
I am developing now the FW for the upgraded version...
Hi devzone-team,
my application (custom board with nrf52840, sdk 16.0.098 ) uses 12 timers and it's organize in the 3 parts: uart, a pwm-bus ( proprietary) and ble-scan...
hi,
my application use boot and soft device.
Is possible with the application erase only the customer register in UICR ? (of course switch off the soft device)
This...