Hi I'm testing the current consumption of the external qspi-flash on nrf5340dk [ MX25R6435F]. I have used ppk 2 to measure consumption with the dk and also have used a power...
Hi,
We are using nrf21540 in GPIO mode + mode pin ( and CONFIG_MPSL_FEM_NRF21540_RUNTIME_PA_GAIN_CONTROL) with an nrf52833.
We are developing under nrf connect sdk 3.0...
During the development of a Matter over Thread product, I encountered the following issue:
After adding two Matter over Thread devices (an OnOff Switch and an OnOff Light...
Hi Nordic Teams :
I would like to check the current consumption by BLE DTM.
1. Is the table measurement is from 3.0V input?
2. I find the condition in the datasheet...
HI ALL,
nrf54l15dk,v2.8.0,peripheral_uart demo and no changes have been made.
Then add the following content to prj.conf
sysbuild.conf
mcuboot.conf
At this...
I'm developing my application with nrf 52832 and nrf SDK v17.
I know NCS is more powerful. I'm currently learning how to use it.
But now.I still need my application with...
I'm writing a wav file from the nrf52840 board to the nor flash w25q128jv with a capacity of 16mb but it seems that I can only operate on the first 2mb, even when dividing...
Hi. I'm new to both the nRF24L01+ and to this forum.
I'm intrigued by the prospect of using these amazing little transceivers as RF modems. Because I find elements of the...
Hi,
On SDK12.2, I replaced main.c in ble_app_template with one in twi_scanner and modified sdk_config.h.
But, no expected log, even "TWI scanner.", issued to terminal...
Hi,
I want to add a service to the "ble_app_beacon example" that i can change
the value of the major and minor directly via nrf connect, some one can help me
to add the...
If I leave the CE pin in a HI state, and assuming I have the PWR_UP = 1 and have loaded the Tx FIFO with data, will the data be transmitted by merely setting PRIM_RX to a...
I've paired ble device with android and then device went out of range and wen ble device comes into range device will connect at that time do we get any callBack???
Hi,
I'm looking at increasing the sensor update rates for the Thingy:52, and get more frequent readings into the sample app. Let's assume I want to change the temperature...
I've been trying to use the Device Manager to store and recall bonding information for use in whitelists. Unfortunately the dm_whitelist_create function always seems to return...
I have recompiled the secure boot loader, s132 and it works great on the dev board but not on my board. The difference in boards is minimal with the exception of the fact...
Hello Everyone,
I have a basic question related to custom BLE service 128-bit UUID.
I know the custom ble service base UUID is the "00000000-0000-1000-8000-00805F9B34FB...
Hello,
We are trying to change Connection Interval when both of Central and Periphera become Sleep mode and either of them becomes Active mode to reduce Power Consumption...
Hello everyone,
My IC description: nRF51822 QFAAHO, which belongs to IC revision 3 and, as the PANv3.0 says, "1V2 + HFCLKarerequested always when the GPIOTE task is configured...
I am using nrf51822 with SDK12.3 + S130 as a BLE peripheral device. I want to pair it to multiple central devices and use button to switch between them.
I tried to filter...
