Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hi,
I would like to know if it is possible that Android OS can know a specific device (has ever connected before) is advertising and OS notify a specific App to connect...
Hi,
I am reading some data from an accelerometer using the nrf51822. Now i would like to save this data offline in the nrf51822 itself, and after i have some data send...
Hello Everyone ,
I want to do application update over the air using BLE. I am using PCA100028 DK, SDK 7.2.0 and softdevice s110 7.1.0 .
I am using the method given on...
Here are my functions which i wrote for reading / writing the i2c slave device ( after reading reference manual (nrf51422) . Unfortunately they are not working. Plz help me...
Hello, I have established the connection between two pca10001 boards, one as central and one as peripheral using multilink_central and multilink_peripheral. I have serial...
Hi,my friend,
Now,I use nrf905.Situation is as follows:
I use the NRF PCB circuit of data manual.Nrf905 work, often loss of data.
1.The Product host is to use the stick...
Hi,
I received the NRF_ERROR_NO_MEM error when add multi-service using S110.The latest sd_ble_uuid_vs_add() function return this error.The softDevice is SD8.0.0,SDK is v8...
Hi,
I want to use the Blend Micro with more security. I want use a passkey for the Bluetooth connection. For example through the iOS Device.
Is it possible? Static passkey...
How do I receive multiple signals simultaneously at a single receiver (433MHz) with multiple transmitters ?
I am working on a polling system. This one is similar to the audience...
Hi,
My application has 2 service. 1 service requires encryption but the other does not. As per my current implementation (ref from example code), the peer always performs...
I'm a beginner, the question might be simple but its really important for me.
where does this error codes get store??
How to make use of err_code and whats the best way...
Hey everyone,
I'm getting a really weird error. I'm using two dev boards for my application: a PCA10001 board (MBED enabled) and a PCA20006 beacon board with Segger's j...
Hi, I am using pstorage to store and read back data in Nordic 51822 platform, with SDK5.0.0 and SD6.0.0, here is the code how I use the 'pstorage application':
// Initialize...
