Hello Team,
Could you please share some sample application or procedure to handle power modes (Sleep, Deep Sleep, etc) of the nrf9160.
Please let me know.
Regards, ...
Hello,
I have tried twice to request for SUPL license for getting A-GPS working but it has been denied both of the times. I think first time it got denied due to mismatch...
Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
Dear guys,
now I use SDK12.3. My application DFU is works fine base on buttonless dfu sample in pca10028.boad ic is nrf51822AC. IROM1:0x1b000.0x25000.IRAM1: start-0x2002fe8...
I'm trying to get the sample "nRF5_SDK_12.2.0_ble_app_hrs_pca10040_s132.zip" working. It was provided in the "Development with GCC and Eclipse" tutorial. The dev board I'm...
I'm learning how to use TWI with the nRF52 PDK, and I have it connected to a LSM6DS3 module for testing.
When initializing the TWI, if I use the following line, it works...
i want to connect my nrf51822 device to only one phone for secure,now its able to connect all the phone so its not secure, i think its possible using whitelist so anybody...
I am new to Nordic and developing an application using nrf52 chip.
I am trying to use timer0 example provided in the SDK for Timer1.
I did following changes related to timer...
I've got an mBed application that includes a softdevice (s132 - 2.0.1) that is installed at 0x00000-0x520000 and works as required. I created a test bootloader using the example...
Hi,
In the attached diagram, can you please let me know what is the time between green and sky blue , which would be (I assume) the same as sky blue and navy blue (please...
Does the nRF51422 require a license from ANT for use?
Their website specified that it is not for dedicated hardware but might be for multi-protocol devices.
Reference...
I am attempting to do some development using the usbd_hid_generic example peripheral code. I am using some C++ libraries in this project, however there is syntax in the usbd...
I would guess that's basically the whole point of the structure, but I want to make sure that the location of the SoftDevice Information Structure and the relative positions...
I want to use the nrf24l01+ with the se2436 apmlifier, but the input of the amplifier requires an input of 100ohms balanced, while the nrf24 has a balanced output of 15ohm...
Hello,
I am using following component for my project, 1-nrf51822,2-SDK 11 3-S130, 4-BLE400 board, 5-Keil IDE. I am also using SDK 11.x HID example for my base program....
