I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi
I have done several projects with the nRF905. I know the device quite well. Normally I use the CD, AM and DR interrupt pins to determine the status of the device, my current...
How can I do that? Which pin is available for this?I am trying to controlled with my smart phone due to an application which i design,how can i import this part to my original...
Hi,
I'm using S130 with PCA10028 and I would like to connect my central device to multiple peripheral at the same time.
According to my understanding, the only way I...
Hello everybody,
we want to extend out Central device to dual role (Central + Peripheral). I just finished the migration to SoftDevice S130 and was about to migrate the...
Are there any laws or regulatory certifications that state a wireless or Bluetooth device must be able to power off or at least stop transmitting through user action? Can...
My project is compiling and working, but there is this very annoying issue when Keil thinks there is a problem with __STATIC_INLINE in the file cmsis_armcc.h.
It indicates...
I can see in nRFgo Studio that I can set a custom advertisement type/value to be included in the advertising packet. I would like to modify this data at runtime. I see plenty...
Hello all, before I decided to write my own question I read the forum thoroughly. How ever no aid found to solve my problem.
At first I want to make "just work" bonding(pairing...
Hi, we are currently using the nrf51822 for sensor communication.
Is there a possibility to make it airplane ready? Which means, no rf emmision for the ble for some unknown...
Hi,
I'm trying to interface the nRF8001 using an MSP430 device (specifically Adafruit's breakout board and MSP430fg439) for sending analogue data from the sensor hosted...
Hello all,
(I'm 99.99% sure the answer is "yes", but I've been asked to find out for sure, so...)
Can the (S310) SoftDevice be updated via a bootloader, on an nRF51...
i set the service uuid as 0x0 and after i debug the program, i can't find my device. i don't know how to solve the problem. maybe i should not use 0x0?
thanks for you help...
I am using Bluefruit BLE sniffer based on nRF51822 chip. Now Wireshark seems to decode most of the messages but not those where the actual information is being transmitted...
