Good afternoon! As the NRF7002 takes about 400ms to start up from shutdown, we would like to use the very low power deep sleep function for quick startup. Unfortunately, due...
Good afternoon! As the NRF7002 takes about 400ms to start up from shutdown, we would like to use the very low power deep sleep function for quick startup. Unfortunately, due...
Hi,
I would like to know the difference between the nRF52840-QIAA & nRF52840-QIAA -R7.
What is the significance of R7 here. Not able to find it in any conclusion ...
Hi, I'm working with the DWM3001CDK (nRF52833 + DW3110) and currently using SPI to interface with the DW3110 for UWB communication.
I'm trying to use a second UART to communicate...
Hi I am developing in 54L15. Now use DPPI to link
TIMER10's PUBLISH_COMPARE[3] ---> RADIO SUBSCRIBE_STOP,
it works fine.
Now I want to trigger a GPIO signal through...
Hello, I have an issue regarding the current measurement of my nRF7002DK_nRF5340. I am trying to measure the current consumed during the transmission of a carrier on a Wi...
Post:
Hi Nordic Team,
We are currently developing a product based on the Raytac MDBT50Q-1MV2 module, which integrates the nRF52840 SoC. Our firmware is built using the...
Hi,
I have an old project running on nRF51822, with SoftDevice SDK v8 - S110 mode.
I'm trying to migrate the project to a nRF52832 with SoftDevice SDV v12 - S132 v3 mode...
I have a question about Makefile template used in all samples in SDK12.x
What is the sense of:
$(foreach target, $(TARGETS), $(call define_target, $(target)))
-include...
Hello,
I am facing many communication error with code 1 when using the UART.
Everything is working fine until my client reads long characteristics (in my case it is about...
Hi
We're trying to get the BLE packet size using:-
uint32_t nrfErr;
uint8_t PacketSize;
ble_opt_t opt;
/* Get the extended length BLE option */
nrfErr = sd_ble_opt_get...
Problem:
We trigger HardFaults reproducibly. By manually unwinding the stack we have traced the source of the error back to the TIMER2_IRQHandler in Gazell.
We can see...
Hello,
I am using SDk 11.0.0 and I am trying to integrate the DFU from the heart rate example into the my code, which is based upon the BLE UART (NUS) example. When I run...
i want use s310 in nrf51422 v3 but i cant find it in sdk 12 and i find it in sdk v9 is this correct that ITS IN SDK 9 BUT ITS NOT IN SDK 12 ?
next q is when i use example...
Hi,
For now you propose the "nRF5 IoT SDK v0.9.0 " but mention about the IoT SoftDevice "This SoftDevice is a technology prototype only. Therefore, it should never be used...
Hi,
Our device is slave device with LCD displaying.We need to implement the function as below:
Within range of our slave device, if multiple master device like combined...
First let me explain what I mean by that question, I walked through chapter 17 and was under the impression that there's an "automatic" hardware package wrapper in place to...
In my case LEDs (N<10) would be animated (think pulsing).
My only concern is that the BLE core will limit the possibility to control the LEDs in real time, thus causing...
HI, all Nordic Developer
I know that the S130 soft-driver supports both functions concurrently.
But, I am trying to combine ble_app_beacon and ble_app_uart_c to perform...
