This previous question about multiple advertisements seems to be related to softdevice 7. I was unable to get a similar example working in SD/SDK8
My end-goal is to add...
We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hello ,
I'm designing an embedded system with one of your RF chips (NRF24L01+) and as far as I searched for the datasheet , It seems like NRF24L01+ doesn't have a hardware...
Hi,
This post is very old.
devzone.nordicsemi.com/.../
I have a nrf51822 chip and I'm using it as BLE and it exposes some service and characteristics and it is working...
Hello!
I set up a project using NRF24L01 and a patch antenna ceramic, the type used in GPS.
In fact, I tested several types of antennas, F, F inverted, GPS, Loop. But...
Hi, Nordic:
I'm testing the DC/DC function as to reduce the radio current. I have done the DC/DC test using pca10028 DK with the code below (SD v2.0.1, SDK11) :
void...
Hi,
I want to develop an ANT+BLE application using the D52Q module. I found the BLE serialization documentation but it's referred to S130, S132 SoftDevices. Is it compatible...
I have recently started getting the following error during a DFU using MCP.
Capture.PNG
Any idea as to the cause of this? What is the best way to debug this?
I am...
Hi,
I am wondering why PSTORAGE_NUM_OF_PAGES is by default set to 2 in the DFU project.
From what I understand the pstorage_raw.c module is used to update bootloader...
In iOS, it is possible for different apps to send data to the same characteristics in the same device by calling retrieveConnectedPeriphrals… Is there a way to identify the...
Hello,
currently, I am trying to get the SPI (master with EasyDMA) to work. I interfaced it with an LED driver IC , which needs some signaling (via GPIO pins) along with...
Hi,
I'm using the nrf52 board with sdk11.
I want to know that i have 100 beacons and my nrf52 is a cenral.
1)How many beacons can scan by the central at a time?
2...
Hi, I have managed to get my nrf51822 DK kit to read LDR sensor values. However the characteristic values are represented as hex on the master control panel and also on the...
Hi,
I'm i'm sniffing the NRF51822 s110, using the Nordic's BLE sniffer (on s120).
The BLE device is in a connection, and do a connection parameter update to a new interval...
Hi All,
I'm trying to update the application firmware of an nRF52 board with OTA DFU.
I have managed to create a .zip package (under linx, gcc compiler, Nordic SDK11,...
I want to make a program for wireless accelerometer with a microcontroller "nrf51822". I prepared the code however I face a problem with the ".h" files such as "nrf_error...
Hi All,
I'm having trouble running one of my I2C sensors connected to the nrf52 when running at a 200hz sampling rate.
Interestingly enough, the same sensor seems to...
I mean what kind of header information and stuff besides the data. I could only find this for advertising packets.
A graphic or list like this would be nice:
byte 0...
