I'm having some trouble successfully entering ON,IDLE mode. I have pared-down my application to do the following:
Initializes the app_timer using the scheduler:
...
I want to control GPIO toggle by PPI. Timer1 is in timer mode. CC[0] is 1000, and CC[1] is 8000.
I use compare[0] to toggle gpio18 by PPI. I also want to use compare[1] to...
Hi,
I use two evk board to connected and test the uart serialization sample(ble_s110_serialization), one is ble_app_hrs and one is ble_app_connectivity. But I have one...
I am getting get BLE_EVT_USER_MEM_REQUEST and BLE_GAP_EVT_CONN_PARAM_UPDATE event, when writing to ble device, sample code did not handle these event, and seems no document...
Hello:
Why do I erase SDK5.2 version of flash and read not, in SDK4.2 can. I tested nrf51_sdk_v5_2_0_39364\nrf51822\Board\nrf6310\flashwrite_example is a good example.However...
before i write the flash, it has been erased.so ,its value is all 0xff.
when i write 0x00 to flash address 0x0001,the value read out is not 0x00 but 0x01,and the value in...
Hello, Is it possible to use a RedBear V2 with the DAPlink as a Bluetooth dongle, apparently, the DAPlink can function as a USB-UART bridge. I'm new to SoC and am trying to...
Hi
I am trying to load my shiny new NRF52840 dongle with a simple blinky app using the nRF Connect (v2.4.0) but I get an error stating that the 'Region starting from 0x0...
Hi,
I follow exactly the same as "Interactive mesh provisioning and configuration" and stuck at "Adding a Light Switch client (optional)" part.
Everything looks fine,...
I am working on a J-link command line.
i just want to lock a device after a write a binary file into device.
In j-link there will be option for a unlock a device like...
Hello,
I'm developing a program using nrf52832 DK and SDK V15.
I want to activate the SPI transmission when NRF_RADIO->EVENTS_END occurs using the PPI. I follow the PPI...
I am trying to connect an lcup heart rate sensor which is an analog device . i am using the SAADC example t interface it to the NRF52 board, but iam not getting the expected...
After unplugging the USB, disk initialization fails in usbd_user_ev_handler function function (case: APP_USBD_EVT_STOPPED). If I connect and disconnect a second time, it works...
When using the USB for logging date, I am able to see my file by simply plugging a USB connector; I can also view the contents of the file by double clicking on it. In such...
Hello,
I'm integrating mesh and freeRTOS and having problems with interrupts priorities on both sides. It's a little bit confusing to set the interrupt priority on each...
Hello there,
I am working on the iBeacon project.
I want to get the distance to 50m.
Now it detects 5-10 meters.
Soldermask on antenna
Project inspired:
Thanks...
nrfConnect for MacOS won't allow pairing of a BLE peripheral with a nrf51 based dongle.
nrfConnect Version 2.4.0.
dongle PCA 10031 V1.1.0
Mac OS version 10.11.6
A...
Hello, so I have a central and two peripheral cards that each send their counters to the central. What I want to do is compare each of the two counters. But there's a problem...
Can I use the ble_advertising module for the BLE_GAP_PHY_CODED ? Currently my Coded PHY parameters without the module are defined as:
Following the example at NordicPlayground...
