I am looking for cheapest (up to few hundred USD) and simplest Arduino basic solution to track real-time RFID tags distance (also direction if possible) without additional...
Hi all,
I am new to Nordic semiconductor but I could be interessed by nRF9E5. To check if it could fit my requierement, I would like to know if it possible to configure...
Hi,
I am using ADC without external reference and no analog input in order to measure the battery level with a timer (code at the end).
I am also reading several ports...
Hi,
I'm programming the nRF51822 and save some user data into the FLASH by using pstorage_update . It works fine if I set system off mode, and wake it up. I can read back...
Hi,
I have been using nRF51822 with my Android app using Android's Bluetooth Low-Energy APIs.
In order to get more details, I am currently working on integrating the Android...
I'm looking at interfacing a typical Wheatstone bridge sensor to the nRF51822 ADC. This particular sensor only requires a mA or two for excitation and the output fits within...
When use the "nRFBeacons" app to update the info on my beacon the following happens:
Go to update tab.
Select "Connect"
Press "SW2" on beacon and see the LED begin flashing...
Hi everyone,
I want to set LF CLK source to XTAL without softdevice. But, LFCLKSTAT value is 0x00010000(CKL RUN, CLK SRC = RC) after clock start.
So, I checked same test...
When drawing lines of equal start and end x, y coordinates the GFX library shall draw a rectangle with thickness applied. If the value of the opposing axis has a start value...
Hi everyone,
This might seem like a silly post, but this happened.
I build and ran the example QSPI code given in the sdk.
But after that if i try to run my own code...
We're writing code that does dynamic pin assignment which may change over time. This question is about how the crossbar deals with conflicting pin settings.
If I set the...
Hi Technical Team,
nRF52832DK is running on central role with the below
SDK version : 12.3 IDE :IAR
It is working (connection,just work pairing,bonding, & reading/writing...
Hi,
I have connected the components mentioned in the reference schematic from the official website to my nrf52832 chip. Is there any easy method to know whether it is working...
Hello Im preparing a device that uses nRF51422 for CE and FCC testing. I need to disconnect the antenna and put a connector in it's place for the testing. I have doubts about...
Hi,
I am writing Android APP based on nRF Toolbox code.
For the first time to call requestMtu to change MTU to 247, everything works well. We can see the negotiated...
Hello, I am trying to use a PI3 as a provisioner for a bluetooth mesh network.
From my understanding,if I use interactive PyACI, I would need to plug a dev board to interact...
Hello,
We are developing an datalogger application that will push data to a server on the cloud using a cellphone app as intermediate. We are testing a BMD-350 DK board...
Hello,
I successfully ported DMP library https://github.com/Snowda/MPU9250 .
The project is initializing but when I read the fifo_count from FIFO_COUNTH (0x72) register...
Hi everyone.
I have a problem with Mesh network.
I try to reset node from mesh network, using function node_set().
When remove node from network, on mobile app "nRF...
Greetings everyone,
I am just trying to find out what the (EO) in the NRF51822-CEAA-R stands for. Could someone please provide documentation for this?
Thanks,
R...
