Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
I have worked on a new project which would convert our NRF51 project into NRF52. I have succeed in compiling and linking code for this new NRF52 project. When I start debugging...
Hello,
I'm trying to port an Eclipse project template that I have set up for the NRF52 using SDK 13. I want to downgrade the SDK to v12.3 in order to be able to use the...
Hi! For a custom board, I have my app working ok. So I wanted to add the dfu secure bootloader to my project. I Had no problem to do that, both app and bootloader start ok...
Hi
Why does making an input differential lose a bit on the nRF52. According to the data sheet, if a channel is 10 bit and using 0.6V reference and gain 1 and input is 100mV...
Hello.
I am trying to port bootloader project from SDK to SES. But I do not know how to write data to UICR.
Steps what I've done:
My nRF52832_xAA_MemoryMap.xml looks...
Hi, I was trying to test the CTS example with a PCA10040 board.
I use
Nordic's SDK 14.0
64-bit Windows 10 machine (the PCA10040 is connected to this machine...
In nRF5_SDK_14.0.0_3bcc1f7\components\libraries\usbd\app_usbd.c
if APP_USBD_CONFIG_LOG_ENABLED is put at 1, the compilation fail. It is solved by adding NRF_LOG_MODULE_REGISTER...
when i use sd_ble_gatts_hvx() send data to ble stack, after 300ms later ,i get the ble stack event BLE_EVT_TX_COPLETE , how i can reduce the time(300ms), let the data send...
how i can send data 1500byte per second，use the sd_ble_gatts_hvx(). because i send the first package use sd_ble_gatts_hvx() and 300ms later i get the BLE_EVT_TX_COMPLETE,...
