I need to create timeout below 1ms. I would pretty much like to use timer for that because I do not want to hold the cpu inside cycle. For me it is not important the exactness...
Hi,
While testing the device firmware update through the nRFtoolbox android application, i get "device has no required service" error more frequently.
I use latest version...
I'm having some trouble successfully entering ON,IDLE mode. I have pared-down my application to do the following:
Initializes the app_timer using the scheduler:
...
I want to control GPIO toggle by PPI. Timer1 is in timer mode. CC[0] is 1000, and CC[1] is 8000.
I use compare[0] to toggle gpio18 by PPI. I also want to use compare[1] to...
Hi,
I use two evk board to connected and test the uart serialization sample(ble_s110_serialization), one is ble_app_hrs and one is ble_app_connectivity. But I have one...
I am getting get BLE_EVT_USER_MEM_REQUEST and BLE_GAP_EVT_CONN_PARAM_UPDATE event, when writing to ble device, sample code did not handle these event, and seems no document...
Hi,
I'm experiencing frequent crashes in the softdevice on an nrf52832, running SD version 6.0.0 with SDK 15.0. The crash seems to occur when interfacing to the device over...
So I can live with the 60uA power draw I get shortly after a power cycle but the strangest thing happens. Over a short period of time the power consumption ramps up to, well...
Hardware: customized board based on PCA10056
SW: nRF5_SDK_15.2.0_9412b96
Change:
Merge ble_app_blinky example into blinky_rtc_freertos.
/cfs-file/__key/support-attachments...
NRF52832
SDK 15.2
Two MCUs communicate through serial port. If the other MCU is not powered on, nrf52832 will not run (LOG error > app: Fatal error). If UART is not initialized...
Hi everyone,
These days, I am thinking about how to make some upgrade about the sound module of thingy52.
It would be quite funny to make some other sound samples rather...
I want to know the project which code was developed with IAR,the project can port to keil MDK? If I could,where do I need to change,and how to do it .thanks
I use SDK15...
Hello, I have recently updated our CLI backend to use LIBUARTE and it seems to be much more reliable. I have a few assumptions I would like to clarify and a few questions...
I am about to start new quite complex project with nRF52 and I thought that maybe it is high time to use freeRTOS port from SDK. As the device is going to be powered with...
We are experiencing some mysterious but very rare events of MCU going into system OFF mode. We are using nRF51822 and S110 v7.3.0. The wake ups are most likely caused by a...
Hi,
We are using nrf51822 QFAAH00 with SDK 110 v10.0.0 with softdevice 8.0.0 in our project, In Application we are using gpio,timer,uart interrupt handler, In main function...
Hi support team,
I'm using nrf52840 with softdevice 6.1.0 and sdk 15.0. I started from the ble_connectivity example as my central and used pc-ble-driver on my host PC as...
Hi,
I´m looking for a Bluetooth low energy proximity sensor with this (or similar) characterisics:
One main (receiver) module and many secondary (transmitter)...
