I posted another question along these lines, about using the Timeslot API to get observer behaviour with the S110 v7.0 SD, but I am having trouble getting it to work.
Are...
I'm interested in creating a time of flight algorithm and am trying to calculate what to expect for accuracy.
Is it possible to get an IRQ from when the sync arrives at...
hi all ,
how to enable GPIOTE PORT and IN[n] event simultaneously ?(not same pin)
i enable the GPIOTE to trigger interrupt event.
one for the keyboard which need multiple...
Hi All,
I am using nRF51422 with softdevice s310. And implementing Cycle speed and cadence receiver. most of the data processing is fine but i am facing one problem.
...
Hello Nordic Team,
I have a problem with programming the nRF24LE1 chip.
I am developing a small system, which consists of a uC STM32F4xx and a nRF24LE1 Radio Module. The...
Hi,
I'd like to learn about the app compatibility for the new OTA DFU that ships with the new SDK 6.0.0 and S110 7.0.0. I am using a nRF51822 board and I've observed that...
I was on Instagram, and I won a green nordic 52 from Nordic. I got it, became frustrated because I didn't have a JTAG debugger, and flashed espruino onto it with nRF toolbox...
Hello,
I have a question regarding the correct way/good practice of programming with the use of SPI. I am using SDK 15.0.0.
I've written some code in a source file peripheral...
hi.........
i am using nrf52832 and segger 15.2
i am merging the two programs in order to send the data through ble to phone(uart app)
i am getting the error
undefined...
hi !
I have start to program the SPI example to communicate with the BMP280 from Bosch and i have seen good results so i'm tried to implement the code over ble_app_uart...
hi..........
i want to put my peripheral device in sleep mode ? how to do that?
i tried this one , its shows error
err_code= sd_power_system_off();
APP_ERROR_CHECK...
Dear Nordic Team,
Thanks for supporting.
Currently i am trying to work with multilink central in NUS_C example based on ble_app_multilink_central. The edited code was...
Hi
I installed nRFConnect v2.6 and command line v9.8.1 and want to use PPK to measure current.
When first connect, it will update FW into PPK and works well to measure...
Hi. I have been going through the mesh examples. Now i need to know how to send pings between any two nodes in the mesh. My aim is to first be able to successfully ping a...
I am trying to broadcast a non-connectable advertisement (such as a beacon) while I am connected to a device that I am transferring data via TX. I am working with a nRF52840...
Good morning everyone,
I am struggling since a few days to understand how the SPI communication is supposed to work in the SDK 15.0.0....
So far, I am having some issues...
