hi dear nordic employee:
I tried to build the project ble_app_hrs_c(pca10040) by keil5
but I get an error :
._build\nrf52832_xxaa.sct(7): error: L6236E: No section...
Hi,
I am a bit confused about power consumption when using app_uart_fifo. To save power I put MCU to sleep in between each sent and received byte by using __WFE and __SEV...
Hi! I am building an android app for my project. I am using Proximity , UART and DFU from nrfToolbox app. I have 3 buttons on my home screen dedicated for each of them. I...
Dear Nordic employee:
1、 what do I have?
I have a thingy52 develop kit(nrf52832)
2、what is my purpose?
the quality of thingy52 audio demo is not good(iphone7)...
Hello Nordic,
My development environment:
SDK>> NRF51822_SDK10, SoftDevice>> S130
Example>> ble_app_uart
I am looking forward to your reply!
Thanks.
Best Regards...
Dear friends,
according to "nRFConnect_BLE_User_Guide_v2.0", to set up a local device,i should complete the following steps:
Connect a development kit or dongle to...
Hi
I have add some function call like sd_ble_enable in mesh example, I test to get
then I set the address and all sd_ble_cfg_set is ok
but when I call "sd_ble_enable...
Hi all, I'm working on SDK13.0.0 secure bootloader and I'm curious to know about
Why nordic defined, dfu service uuid(0xFE59) is 16-bit uuid and characteristics in...
Hello,
I am attempting to use GCC with Eclipse. I have installed all the tools, sdk, etc. and have also installed Mentor Sourcery CodeBench to get the Make and rm tools...
Hello,
I'd like to know if it's possible to use this chip to analyze the spectrum in the range of 800MHz 1GHz, and if it's possible to capture raw data. With the information...
Hi,
I am working on SDK13 multiperipheral example trying to add nus in code, but it is not able to send anything to connected android , nrf52 is receiving only 1 byte if...
Hi,
I want a Mesh solution with gateway which is able to connect Amazon Web services(AWS) via MQTT.
6LoWPAN mesh network based on IEEE 802.15.4.
Mesh devices can be...
I'm looking into a project that needs to have BLE to communicate with a user and a mesh network to communicate with multiple data gathering nodes connected by 2.4GHz RF links...
Hi,
I am using nrf52832 for my application. The application share same SPI module for two sensors(with sensors are selected using two chip select pins). Is it possible...
Hello ,
following are my requirements :
to create a secure bootloader which checks app validity at every boot .
the boot loader should also accept UART communication...
I have an Eddystone beacon from minewtech...i've downloaded the nRF connect app onto my android tablet and i can connect to the beacon. the problem is that it's not "taking...
On the nRF51822 Is it possible to check the battery level using the on-board AD, software connected internally, avoiding external resistor divider.
If not what is the best...
Hello,
I've been trying to migrate a project from the nrf51822 that uses s110 7.1.0 softdevice to the nrf52832 s132 1.0.0.3 alpha softdevice. I had to change some given...
How can I found out my NRF51's device Address? (with Softdevice using Random static address?)
Does Softdevice has any API for fetching my device's BLE Address?
As I...