Hello,In normal condition, I use UART,pwm,spi an so on.Now I want to clear the configuration, and enter System ON mode.But I don't want to system reset.
How should I do...
Hi, everyone~
My goal is to collect data from 4 sensors simultaneously using iPhone.
Now, my testing code for sensor nodes is working fine. It was built based on the...
I am an android developer and I am using your nRF Master Control Panel (BLE) product as published on Google play. Below is the link to the app:
play.google.com/.../details...
I want to build a USB dongle, so I purchased the nrf24lu1+ development kit. However, in order to program the target board, it would seem that I need the nrfgo. Is this correct...
Hi Nordic,
I would like to re/program my device using a OTA BLE Bootloader but i don't want others to copy my firmware or at least make it very hard. As far as i know there...
After modifying the ancs example to remove the data and control points, the event_connect() subfunction in ble_ancs_c.c gets called immediatly upon a connection to a master...
I want to establish a link between two nRF8001 devices. Is there an example of how to do it? I am using micro controller on our application board to control the nRF8001 devices...
Dear Developer Zone,
At this time, it is possible to upgrade the firmware version using Bootloader. But, is there any way or any plan to upgrade also the softdevice version...
Hi,
I'm looking for a wireless solution to handle 500-1000 of Clients per area. Because i',m new to Bluetooth i don't know if this is possible.
Requirements:
Network...
Hi,
I using the application download the update firmware, and using the bootloader erase and write the firmware to flash.
And I changed the bootloader code, remove all...
Dear Nordic Developer,
I am using nRF51822 with softdevice.
What is the best approach to have a nRF51822 always discoverable? Like heart monitor for example : no need...
If I receive data on the UART that comes in via its event handler, how can I then create an event to wake up from sd_app_event_wait and do further processing from the application...
400 control modules
I'm starting a project.
I need to reach a maximum of 200 meters.
I work with PIC. I'll have to control 400 MODULE Transceive.
Which model should...
Hi,
I have modified the ble_app_hrs source code with more no of custom characteristics(approximately 10), When i press Service Discovery in the master control panel, i am...
Hi ,
For our application i created 9 rtc1 timer .
all timers are working fine.
but once i stop battery timer and start it again ,it is giving receiver link loss....
Hi,
Actually In our application we have a battery, by external source we can charge it. Now when we connect battery or external power supply directly no error is coming....
hello!
ANT protocol;
have three nrf51922 , A can find B, B can find C. but A can't find C. A. how to communicate with C by B ? And C how to return a reply?
I want to know...
