In my circuit I have a MOSFET which disconnects the battery. There is a GPIO pin which turns this device on and I'm using regulator-fixed to drive it during start-up. A short...
We are currently using ncs 2.9.0 on an nRF5340. We use the BT_HCI_OP_VS_READ_VERSION_INFO to determine at runtime what version of the BLE stack is present. This information...
Hi I'm trying to load a custom board with nrf9160 with the Serial LTE Modem, and route the AT commands to the UART from a coprocessor (ESP32C3) I have followed the guide on...
Hello,
we have a working system on the nrf9161 that works without zephyr. We have our own secure firmware that successfully uses the cc310 after we start the actual application...
Keep hitting my head on this inconvenient workflow.
Edit build config
Select target custom board
Build config
All OK
Edit config again
Target board has been...
I have used the Programmer previously with success. I am attempting to program the Dongle (10059) with a slightly modified version of ble_nusc_usb_dongle. Although it claims...
H ello Nordic team,
I'v found a bug on mqtt sample (using both ncs 3.0.0 and 2.6.1).
Description
Settings CONFIG_MQTT_SAMPLE_TRANSPORT_CLIENT_ID and trying to connect...
Hi, I'd like to use nrf51 dongle to scan for ant/ant+ communication, but I can't understand how to do that... it doesn't work with antware sw and I don't know how to use it...
Hi,
I use NRF51822 to design a ble product,my client require that when in the front of the ble device the app can connect the ble device,and can't connect in the back of...
My Issue,
I need to be able to set radio RCV/TX signals to a specific distance. I would like to control this
through the firmware. Do you have any recommendations or examples...
Hello,
I am using Keil Lite edition and I'm receiving a linker error from exceeding the code limits in Keil. My code is 37336 bytes and apparently cannot exceed 32000 bytes...
Hi,
I'm currently working on a BLE device which works his whole lifetime on one battery. This means we have to save as much energy as possible. This is why we set our advertisement...
Hi all,
Our company is in the process of certifying a device. This device is using a nrf52832 with radio.
We had no problem to comply with the ETSI standard, but things...
I am trying to set up a custom Advertisement in nRF-Connect for Windows, using an nRF52 DK (PCA10040)
In Advertising Setup, I remove the existing "Complete local lame"...
Hi
I am looking for some example code that shows best how to talk to a servo.. If there isn't any, any ideas which example project comes the closest ?
Thanks
J
Hi,
I was reading datasheet of nRF52832, but i didn't see USB topic in that.
But i checked the SDK which has USB example for HID_keyboard and mouse?
Is that Means we are...
I am trying to run the ble-characteristics tutorial code on a custom nRF52832 board ( MetaMotionR ). The blinky example worked just fine after creating a custom_board.h file...
Hi, I have a need to connect to a peripheral device from and nRF52 with a Bonded connection.
My device handles bonding when it is a peripheral, but what is needed to enable...
I'm thinking about doing some power consumption experiments with the new BLE5.0 standard.
Has anyone tried to use this power profiler kit (order# nRF6707) on the new Bluetooth5...
