NRF24AP2 with MSp430F149 . ASYNC 9600 N 8 1
step 1 : reset NRF24AP2 with reset pin , and received a pulsing signal through RTS pin
step 2: send a char (0x4A) to NRF24AP2...
Hi guys,
I am using the gcc setup to program my boards. However for flashing the softdevice I use nrfgoStudio. SO I downloaded the hex file and fashed the siftdevice. But...
How do you create hid information for a joystick and send it over BLE. Nordic doesn't seem to have
primitives for this (they have keyboard and mouse facilities). I'm working...
I use a PCA10001 board as peripheral role of heart rate service and it can be discovered by control panel. But as I download the experimental program of central role of hrs...
I'm reading the source for the nRF Toolbox app for Android 4.3 and comparing it to the Proximity Profile spec from the Bluetooth SIG, which has this to say about path loss...
Hello,
I have downloaded the software related with the "nRF51822 Bluetooth Smart Beacon Kit" in order to modify typical iBeacon's parametres such as UUID, Major ID, Minor...
Hi Nordic,
I used FDS to operate updata to update data more than 10K once, but there was an error. Hint FDS_ERR_RECORD_TOO_LARGE.Can FDS operate more than 10K data at once...
I want to create own android app with just nus service (uart).I'm not very good in android programming, so there are two ways for me doing that:
Use Android-nRf-uart...
Hey guys,
I have another question related to this example.
I've modified the UART example such that UART printing is disabled, and I am calling ble_nus_send_string(...
SDK 11.0.0
SD s132 2.0.1
nRF 52 dev kit
I have been in the process of adding dfu functionality to an existing application.
Currently, I have gotten the dfu to work...
Hi. I'm looking for streaming solution.
I think BT5 will be one of the great solutions.
I refered video as below.
www.youtube.com/watch
It shows that nordic chip...
Hello All,
I am working on one of the project using nRF51822 . in this project it requires multi communication protocols i.e i want to configure as below,
2xI2C
2xUART...
I currently have 2 redbear nrf51822 nano. I want to connect the UART of the nrf51822 to my arduino uno/nano but i dont know how i should do this. I tried looking for a solution...
Hello,
I am using PCA10040 and sdk12.2.2. I am trying to load ble_app_template code. But when I try to flash my code in pca10040 I am getting error as "No Jlink Device found...
I have a nRF51-DK and SDK8+Keil5.
I also have a module that sadly uses an old revision 1 nrf51822. It is connected via SWD to my nRF51-DK.
I could programm it with keil...
