Hello Team,
Could you please share some sample application or procedure to handle power modes (Sleep, Deep Sleep, etc) of the nrf9160.
Please let me know.
Regards, ...
Hello,
I have tried twice to request for SUPL license for getting A-GPS working but it has been denied both of the times. I think first time it got denied due to mismatch...
Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
HI,
I get confused using the ble terms hence i'll try to articulate my query as much as possible. I'm using the nRF52832 board and all i have one service with one characteristic...
Hello,
I want know what is the difference between the three kind of low power mode?
System ON, Full 24 kB RAM retention, Wake on GPIOTE input (Event mode) System ON...
Hello
I am trying to get the angle of the sensor using the value of mpu6050.
I used a formula to obtain an angle using sensor values. However, if I calculate this expression...
Hi,
I´m using SDK v16 on a custom board and try to implement the wake up functionality of the low power comparator. In order to describe the system as clearly as possible...
Hello.
I am programming the NRF52810 breakout board.
Before I am testing the prototype, I am using NRF52832 breakout board, and it works well now.
However, the same...
Hi Dev Team,
I was working with the nRF9160 and started off with the basic UART sample found here : https://github.com/Rallare/fw-nrfconnect-nrf/tree/nrf9160_samples/samples...
Dear every body,
some days before, i raise an issue relate my fault at here: https://devzone.nordicsemi.com/f/nordic-q-a/68010/nrf52810-issue-with-32mhz-external-clock ...
Hello
I'd like to reset using the firmware instead of the reset button on the board, is it possible? I'd like to reset the entire Bluetooth connection when it's disconnected...
HI，ALL：
Now, I am study frequency hopping.I found something might be different. It is more hard from highest frequency to lowest frequency(the same as lowest frequency to...
Hello
I use nrf52832 and SDK v17. I am programming BLE using UART service. So far, there has been no problem with testing with one phone, but if I disconnect the Bluetooth...
Hi, all
I'm using nRF52832 pca10040, s132.
Like 'ble_app_hrs' example, I changed the 'ble_app_uart' example to send data using app_timer.
In the example of 'hrs...
Hello,
I wonder if I can disable saadc interrupt because saadc is under control of ppi in my project and I don't even need saadc interrupt or interrupt handler.
As I know...
